0
How do you change the oil pressure sending unit on a 1988 Cadillac brougham?
Wiki User
∙ 14y ago
it should be right be hind the distributor and u will a need a special wrench at a parts store its round at the bottom an got a wire on it that clips on to the oil pressure unit
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you change the light bulb in the ashtray of a 1992 Cadillac Brougham?
take to cadillac dealer
How do you change the heater core in a 1992 Cadillac Fleetwod brougham?
you dont, a mechanic does
How do you change 96 cadillac deville sending unit seal?
Oil pressure sending unit is located by oil pan in front. Unplug unscrew and install new one
How do you change 96 Cadillac Fleetwood Brougham tire?
Read the Owners Manual....That might help..
How do you change a battery in a 1990 Cadillac Brougham?
you remove the battery hold down brace and voala! its done!
How do you change the driver side headlight on a 1989 Cadillac Brougham?
go from underneath it takes probably 2 minutes to do both
How do you replace a lower level ride on a 1994 Cadillac fleetwood brougham?
change over to air shocks on rear end
Do you have to pull the motor to change a oil pump on a 1988 Cadillac Brougham?
You don't have to remove it, you just have to lift it off the mount enough to get the pan to come off.
How do you change the sending unit on a 1991 4 cylinder ford ranger?
Do you mean the Temp sending unit, oil pressure sending unit, or fuel level sending unit?
Can you change the tire pressure monitor setting on a 2008 Cadillac DTS?
No, if you mean by "change", to change the pressure at which the dashboard indicator or message lights up to indicate low or high pressure. You can, however, turn the system off.
How do you install a sending unit in a 83 Chevrolet pick-up?
There are several sending units in that vehicle such as the fuel sending unit, the oil pressure sending unit, the temperature sending unit. Need to know which one you want to change.
How do you change the oil pressure sending unit on a PT Cruiser?
The oil pressure sending unit on a PT cruiser can be found on the upper front cover of the engine. Remove the retaining nut and the sensor will come out. Reverse the process to install the new sending unit.
