You first remove the coolant overflow reservoir,just unbolt it and move it aside.You then unbolt the elec. device? found beneath the res. and set it aside so you can gain access to the motor mount. After placing a floor jack (with a piece of wood) under the oil pan you remove the motor mount bracket and carefully raise the engine about 2 inches in order to gain clearance to remove and reinstall the belt. Then you will need a belt tensioner wrench (you can rent one from O'Reilys). After releasing the tensioner the belt will come off readily. It's a good idea to replace the tensioner as well while you are there. Reinstallation is reverse of removal. I just did this job on my 99 GLS, and it's not as hard as it sounds, as long as you have a little mech. ability. This procedure applies to the 3.4L V-6, the 4 cyl. may be different.
how do you replace head lights on my 1999 oldsmobile alero?
Show me a diagram of the starter location on a 1999 Oldsmobile Alero
Yes the engine from a 2004 will fit a 1999 body.
what does the engine light on the 1999 olds alero mean
no egr valve on 1999 to 2001 2.4 alero
next to the 5th
Nothing special. Normal mechanics tools.
Their is no 1993 olds alero the first year is the 1999 sorry.
How do you change rear wheel bearing on 1999 alero?
no, no you can't.
No, a wheel bearing should not set off a low tire pressure light in a 1999 Oldsmobile Alero.
First of all, Do you have any specialty brake tools? Ben
At the lower end of the engine Behind the radiator (4 cylinder) At the rear (6 cylinder)
How do you set the clock in a 1999 Oldsmobile Alero? I did not receive a book with the car and I really would like to have the right time in my car.
In the 2000 Alero, it is fuse 34 in the engine fuse box, which is located near the battery. You can check the same fuse for the 1999 Alero and see if that is it.
The 1999 Oldsmobile Alero OBD 2 port is on lower left edge of dash; between storage bin and hood release
you need to remove air filter and some of the exhaust pipe before u can get at it.
The Oldsmobile Alero was produced between 1999 and 2004. The compact car was manufactured in Lansing, Michigan, and was Oldsmobile's last vehicle sold under the brand.
The holes is called the bypass holes I had the same thing happened to my alero
894 for Sylvania.
THERE IS NOT ONE.
As easy as it gets. 123456 123456