answersLogoWhite
Chevy S-10

How do you change the signal lights in a 1995 Chevy S10?


Top Answer
User Avatar
Wiki User
2015-07-15 21:04:09
2015-07-15 21:04:09

im not sure on the 95 model about the front, but the rear signal lights should be the same bulb as your brake lights ( it just has two fillaments). you need to open your tail gate and just on the side (where the tail gate normally covers) there should be two screws, remove these screws and change the lamps. and it goes back together the same way it came apart ( just reverse the proccess

Related Questions

User Avatar

Remove the two bolts that hold the whole trim assembly together. Remove the outer trim and turn signal and then the marker lights to change them.

User Avatar

There is nothing wrong with the reverse lights. It is probably your turn signal switch. They are bad in the 1995 lumina. If you do it yourself it should cost about 100 bucks. Good Luck!!

User Avatar

The hazard switch and the turn signal and brake lights are all incorparated, chances are the 3-1 switch is broke internally check all fuses

User Avatar

either dimmer switch or blown fuse If you are saying that the tail brake lights are working but the third brake light is not....It may be a defective turn signal switch in the steering column.

User Avatar

How do you change dash board lights on a 1995 Mercury Tracer.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.