You will first have to remove the the cover that cover's your valve cover. This can be done by removing the two hex screws that hold this cover on. Be sure to remove the hose that runs along the back side of this cover before pulling it out. Once you have pulled it off, you will notice the spark plug wires going down on top of the engine. Simply remove the wire, and then the spark plug one at a time. When you get the new spark plug ready, be sure to gap the plug prior to install. The owners manual will state the gap (or a range the gap has to be between). Then, spread some anti seize around the threads before you put the spark plug into the engine. Put it in, tighten it down until it is wrench tight, and then put the spark plug wire back on. Repeat this step until you are all done. Replace the cover in the reverse order as described above.
4
More than likely it needs spark plugs and new ignition wires.
If you are not able to located the spark plugs on a car, you need not be working on it. If you can't use the correct grammar, you shouldn't be using a computer... The spark plugs are under the black plastic cover on the top of the engine. The cover is held on by 4 Allen screws.
How do you change oxygen sensor on a 2006 Chevy aveo?"
.044 in
0.044
0.030
Remove the plastic cover on top of the engine by removing the 4 srews with an Allen key, you will them see the 4 spark plug cables going from Right to Left and down to the spark plugs. Grab the rubber thing the wire goes through, they will require a good yank, do not pull on the wires themselves. The plugs are at the bottom of the hole you just created.
How do you change the wheel bearings on a Chevrolet aveo 2005
no
0n a 2007 it it 0.44
4 quarts