answersLogoWhite

0


Best Answer

If it is the rear sensor, it will be in the differential. If it is a front sensor, it will be located at each front wheel.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the speed sensor on 2001 Escape XLT?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a 2001 Chrysler Town and Country have a Vehicle Speed Sensor?

yes the have a speed sensor a input and out put the input allow your transmission to change gears and the output speed sensor allow your speed to register on your speed domitor


Where is the speed sensor on a 2001 Ford Expedition?

Speed sensor on a 2001 ford expedition


Looking for chevy venture 2001 speed sensor that is located in the transmission?

where is the speed sensor for the transmission located in 2001 chevy venture


Where is the input speed sensor on 2001 dodge ram 1500?

There isn't an input speed sensor.


How do I replace the output shaft speed sensor on my 2001 Kia Optima?

where is the output shaft speed sensor located on a 2001 Kia Optima?


How do you change the thermostat sensor on a 2001 Chevy cavalier?

how do you change a thermostat sensor in a 2001 Chevy cavalier and where is it


Where is the Output Shaft Speed sensor on a 2001 Ford escape?

Left side of transmission remove wheel and plastic guard it will be on the upper left at approx 2o'clock


What kind of transmission does the 2001 Ford Escape have?

The 2001 Ford Escape has a 5-speed manual.


What is the speed idle control on a 2001 ford f150?

Speed Sensor The sensor is located on the rear axle housing.


Is there a speed sensor on a 2001 dodge ram 5 speed tramsmission if so where is it located?

No speed sensor on the manual trans. The speedometer signal comes from the rear axle speed sensor.


What is an ALC sensor?

how do you change ALC sensor on 2001 Grand AM


How do you change abs speed sensor on a 2001 Nissan maxima gle?

Remove the wheel Trace the speed sensor from behind the rotor to a connector disconnect the connector unscrew the bolt that's attaching the sensor to the rotor platform You might have to pry the sensor from the rotor platform geraldfulsom34@yahoo.com