Best Answer

Unhook your battery, locate your starter........ which should be behind A/C compressor there are 4 bolts, two in the front and two behind the starter.

User Avatar

Wiki User

โˆ™ 2009-12-01 14:53:01
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you change the starter on a 1987 Buick LeSabre?
Write your answer...
Related questions

Where is the bolt to change the starter out of a 1987 Buick LeSabre 3.8?

There are 2 bolts that hold it to the rear of the engine.

Where is the thermostat on a 1987 Buick LeSabre?

Where is the thermostat located on a 1987 Buick LeSabre?

How do you change the flywheel and starter of a 1987 Buick LeSabre?

Get a manual on your car from the parts store or from AUTOBOOKSONLINE.COM. This is not a job for the backyard mechanic as you have to hold the engine while the trans is pulled.

Where is the relay located in a 1987 buick lesabre limited?

where is the relay located on a 87 lesabre

Where is the voltage regulator on a 1987 buick lesabre?

inside of the alternator

How big is the gas tank on a 1987 buick lesabre?

I have a 1990 lesabre and im 90% sure its a 16 gal.

How to fix an Antifreeze leak in 1987 Buick leSabre?

depends where the leak is, and how bad it is.

How do you fix a fuel injector on a 1987 buick lesabre?

no fix,replace with new only.

How do you open an 87 Buick LeSabre with a slim Jim?

The lock assembly is located in the center of the door panel of 1987 Buick LeSabre. Use of a Slim Jim is only legal for locksmiths and law enforcement officers.

Where can you find a fuse box diagram for a 1987 Buick Lesabre? has alot of helpful info

How do you change the starter on a 1987 virago motorcycle?

How do you change the starter on a 1987 virago motorcycle

Where is the fuel relay located on a 1987 Buick LeSabre?

It is with all of the relays in the center of the firewall under the hood.

Where is the fuel pump fuse located on a 1987 Buick Lesabre?

Fuse panel. Open and read your owner's manual.

What causes the serpentine belt to break on a 1987 Buick LeSabre?

Old age Frozen or misaligned pulley

Which Lamborghini is slow?

All of them, if you want a blazing fast car, go with a 1987 Buick LeSabre, or a 1994 Toyota Rav4

Where is the fuel filter located on a 1987 Buick LeSabre?

the filter is located right under the driverside just in front of the rear wheel

Where is the lower pressure port to recharge the ac on a 1987 Buick LeSabre?

it is on the passenger side of the engine compartment, and is part of the big silver accumilator.

How do you repair the driver side window on a 1987 Buick Lesabre that has slipped off its track?

Mine is 1990 LeSabre,is there any difference too rule? Too take the dood panel off drivers side front!? Too get too window/track?

How do you change a starter in a 1987 Cadillac Eldorado?


How do you change a starter in an 1987 88 delta Oldsmobile?

disconnect the battery, then the wires from the starter. Then remove the bolts holding the starter to the engine.

How do you get a diagram of how to put the rear brakes of 1987 Buick LeSabre back together?

You can purchase a Hyanes repair maunal for about 10 dollars. It will have pictures and step by step instructions on how to repair your brakes.

How do you change the starter on 1987 blazer s-10 with manual trans?

Remove the positive battery cable from your 1987 Chevrolet Blazer battery. Remove the starter cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.

Where to connect a code reader on 1987 Buick Lesabre?

Theres a small opening in what appears to be the airconditioning duct work middle of dash under ash tray you have to practically get on the floor on your back to see it.

How do you replace the lower ball joints in a 1987 Buick LeSabre?

You need a ball joint press to do that job. Remove old ball joint with sledge hammer and press new on into control arm.

How do you replace the water pump on a 1987 Buick Lesabre?

Drain the radiator. Remove the LeSabre's top radiator hose. Unbolt the engine water inlet and remove to reach the thermostat. Pull the thermostat out and slide in the new one. Reinstall the inlet and hose before filling the system with new coolant.