Starters and Ignition Systems
Geo Prizm
Chevy Prizm

How do you change the starter on a 1991 Geo Prism?

101102103

Top Answer
User Avatar
Wiki User
2015-07-15 21:00:29
2015-07-15 21:00:29

Same answer as: "How do you replace a starter on a 92 Geo Prism LSI or GSI?" at this same site.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 1991 Geo Prism is a rebadged Toyota Corolla. They are built in the same factory in California. The Prism is a very dependable car with no major problems.

User Avatar

You can find a hood release cable for a 1991 Geo Prism at various auto part stores. You can also check with local salvage yards.

User Avatar

You gotta get under the car and do it from the back of the engine.

User Avatar

Try searching here. How do you change the starter on a 1996 Toyota Corolla?

User Avatar

it is right under the motor. it will be black with a bolt sticking out on the botom of it.

User Avatar

Look at how to replace one on a 93 model.

User Avatar

It is connected to top radator hose on block

User Avatar

Yes the Geo Prism has ait bags.

User Avatar

Yes it should have one located on the backside of the motor, under the intake.

User Avatar

Follow the pos battery cable. It is at the end.

User Avatar

On the 1.6L sohc starter is between the engine and fire wall. By the oil filter.

User Avatar

it can be done but you will have to change all of ur wirring harness from the prism because the prism is basically a Toyota and a storm is a izuzu impulse knockoff

User Avatar

How do you replace power steering pressure hose on a 1993 geo prizm

User Avatar

Maybe a bad alternator, or could need a tuneup.

User Avatar

where is the fuel filter located on a 91 geo prism?

User Avatar

GM made a small car called the geo prism. GM Chevrolet or GEO

User Avatar

From under the car. It's on the backside of the engine between the engine and firewall. Just about smack in the middle.

User Avatar

My 1991 Geo Prizm LSI does not have overdrive My 1991 Geo Prizm LSI does not have overdrive

User Avatar

Maybe on front bottom of engine behind radiator Follow + battery cable

User Avatar

what year was geo prisms made

User Avatar

I have a 93 Geo Prizm and want start is there a relay if so where is it I have a 93 and it is located under the hood near the battery, inside a fuse box. I believe it is marked as a EFI.

User Avatar

The Geo Metro was the only Geo to have a 3cylinder engine.

User Avatar

I've been over 110 in my prism


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.