You gotta get under the car and do it from the back of the engine.
Early 90's models (Toyota brakes) just remove 2 large bolts holding the caliper on and pull it off - then the pads can be replaced. Retorque to 60 ft. lbs.
Remove the starter cables. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.
Around $110 for new, $90 for remanufactured,
The cost of the starter would be about $90. The labor would depend on the company that you use to put in the part.
90
you probably have a bind the burning smell is probably the wire going to your starter you need to find out what it is, try tightening the starter then replace if need be
A right angled isosceles ie. a 45 - 90 - 45 degree prism is called a totally reflecting prism.
0.028 geo tracker 1990, 8 valves 2 doors
There is a fuse block under a removable cover on the wall to the left of the driver's seat underneath the dash. The next question is this: The owner's manual gives fuse numbers and values. How do you tell which fuse is which number?
take the old one off, put a new one on. one week later, replace again, and kick yourself in the private parts for buying a cheap knockoff.
yes a,90-99,willfit a geo tracker.
Unfortunately the starter ois located in the valley between the cylinder banks you have to remove the intake to replace it.(very labor intensive procedure) intake gaskets are about$90 and the starter from Autozone is about $250. you better know what you are doing befor you tear into this engine....