Early 90's models (Toyota brakes) just remove 2 large bolts holding the caliper on and pull it off - then the pads can be replaced. Retorque to 60 ft. lbs.
try your public library buy a haynes manual 15.00 bucks
Same answer as: "How do you replace a starter on a 92 Geo Prism LSI or GSI?" at this same site.
The average cost to replace a transmission for a Geo Prism will vary depending on the cost of labor and the year of the Prism. On average, it will cost between $3,500 to $4,000 dollars.
From under the car.
To tighten the emergency brake cable on a 1990 Geo Prism, start by depressing the brake pedal. Next, locate the parking brake equalizer bar. Rotate both rear tires to feel the brake shoes slightly drag against the brake drum.
Look at how to replace one on a 93 model.
Raise and support vehicle Remove wheel Re-install 2 lug nuts to hold rotor in place Remove caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully compress piston into caliper body Replace inner and outer brake pads RE-install caliper PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
Yes the Geo Prism has ait bags.
i dont really know
You gotta get under the car and do it from the back of the engine.
How do you replace power steering pressure hose on a 1993 geo prizm
To replace the window crank handle on the 1993 Geo Prism, first remove the interior door panel. Then, access the screw that holds the window crank in place and remove it. You can then remove the handle itself.
in the fill resivor attached to the master cylinder assembaly
The break light switch is located on the backside of the break peddle arm.
where is the fuel filter located on a 91 geo prism?
GM made a small car called the geo prism. GM Chevrolet or GEO
on my sons 95 prism i had to loosen the nut on the brake light switch and turn it in a couple turns then retighten the nut, works fine
The rear brakes on a 1996 Geo Metro are changed by jacking the rear end up, placing it on jack stands, and removing the wheels. The calipers can then be removed, the old brake pads removed, and new pads installed.
Check the bulbs - they are double filamented with the smaller being for the brake lights Check for a blown fuse Check the operation and alignment of the stoplight switch
Remove wheel RE-install 2 lug nuts to hold rotor in place Remove caliper mounting bolts Slide caliper off rotor Use a "c" Clamp to fully retract piston into caliper body Replace inner and outer pads RE-Install Caliper PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
what year was geo prisms made
The Geo Metro was the only Geo to have a 3cylinder engine.