Want this question answered?
There are two O2 sensors for the 01 QX4. One in front of the catalytic converter and other is behind the converter.
Begin with disconnecting the negative battery terminal. Remove the two bolts that hold the starter in place and also unfasten and remove the starter motor cable. The starter is easily pulled out.
Where is the Starter relay 01 civic
1. Disconnect the negative battery cable. 2. Disconnect the starter electrical connectors. 3. Remove the 2 starter mounting bolts. 4. Remove the starter motor. 5. Installation is the reverse of the removal procedure. Tighten the starter motor bolts to 33 ft. lbs. (44 Nm).
The 2001 Chevrolet Tracker starter relay is mounted on the top of the starter. The relay switch is attached to the starter with two retaining screws.
Yes. Yes. Yes.
4 Cyl.?Look at the lower end of engine behind radiator
It is located under the air intake manifold, its a pain to access.
Under the engine in the middle toward the back of the engine
Not as straight forward an operation as you might hope. First, locate the coil packs. The Infiniti has a small coil mounted on top of each spark plug. This is why you will not see any heavy gauge spark plug wires running from a coil or distributor to the obvious location of the spark plug. The coil packs are bolted down to the block with a 10mm bolt. In many cases other itesm, (air filter assembly, brackets loaded with stuff) must be removed even to see the coil packs. Be very careful with the coils as they are expensive to replace ($50+ each). The coil pack will reach down into the engine 8-10" to where the spark plug actually sits. You will need a long socket adapter to reach in and actually remove the spark plug. To change all 6 plugs, plan to spend about three hours if you have never done this before.
If what you are saying is that the starter spins but won't turn the engine, the starter drive (also called bendix) is broken and must be replaced.
Change Your Life was created on 2006-01-25.