0
CAREFULLY! VERY CAREFULLY; You will need a spring compressor; Lift car,Remove 2 bolts on lower strut, Remove 3 bolts on top mount, Remove complete strut-spring-top mount from car. Compress spring CAREFULLY, Remove top mount. REPLACE STRUT. Hint before you remove the two bottom bolts paint or mark location, this way you can put it back close to orignal location, But you will still need a front-end alignment. Be CAREFUL
What else can I help you with?
How do you change an oil pan on a 86 Chevy Celebrity wagon?
Does your 1986 Chevy Celebrity have the 2.5L 4 cylinder engine or the 2.8L V6?
Where is the oxygen sensor located on an 86 Chevy Celebrity 2.5L and is it difficult to change?
Its right up front. Piece of cake to change!
Can I put the ECM module from my 1990 Chevy Celebrity wagon into an 86 Chevy Celebrity wagon?
Yes
86 Chevy Celebrity rim size?
14 inch
Where is the idle air control valve 86 Chevy Celebrity?
Assuming you have a mpfi engine it is in the throttle body.
Where at on a 86 Chevy Celebrity is the PCV valve?
The PCV sits in a rubber grommet in the top of the valve cover.
What size rims can i get on a 86 Chevy Celebrity?
I would suggest that you take your car to a wheel shop and see what they have that will work.
Where is the blower motor on a 86 Chevy Celebrity?
The heater blower motor is under the hood bolted to the heater plenum on the passenger side of the car.
The price for a 86 Chevy Celebrity engine wiring harness for Chevy?
TheChevy Celebrity engine wiring harness would not likely be available new from Chevrolet. The only likely source would be a wrecking yard and prices there vary widely from yard to yard.
How do you change a wiper switch in an 86 Chevy Silverado?
go to eBay and buy a whole setup for the steering column
How do you change power steering belt 86 Chevy celebrity?
To change the power steering belt on a 1986 Chevy Celebrity, first, ensure the engine is cool and disconnect the negative battery terminal. Locate the power steering pump, and loosen the adjustment bolt to relieve tension on the belt. Remove the old belt by sliding it off the pulleys and install the new belt, ensuring it properly aligns with the pulleys. Finally, adjust the tension on the new belt and secure the adjustment bolt before reconnecting the battery.
Can an electronic control unit be bypassed on a 86 Chevy truck?
yes,i have an 86-350 change carb,distributor with mid seventys,and i even blocked of the egr. cost about 700.00 to do it.
