drop serp belt come up through sub frame one bolt in the back and you are done
No, you get an assembly.No, you get an assembly.
You have to remove the headligth assembly. There are 3 nuts on the back, and 1 bolt on top.
You have to replace the distributor assembly.You have to replace the distributor assembly.
A 2004 Chrysler Town and Country does not have an upper ball joint.
A2003 Chrysler Town and Country has a timing chain, not a belt. The chain does not have a service interval.
The 3.8L in a Chrysler Town and Country does not have a belt, it has a timing chain that does not require service.The 3.8L in a Chrysler Town and Country does not have a belt, it has a timing chain that does not require service.
You have it checked at every oil change and replace it when dirty.
A 1998 Chrysler Town and Country would have a 3.8L V6. That engine has a timing chain not a belt.A 1998 Chrysler Town and Country would have a 3.8L V6. That engine has a timing chain not a belt.
Open the rear hatch, there are the pins for the light assembly, they should turn by hand and pull out. remove the fixture and the bulbs are easily removed. They pull out and push back in. replace the assembly and put the pins back in, turn to tighten. Thats it, it takes 2 minutes!
There are two screws on the the door panel.
Open the hood. You may need to make some extra room behind the headlight assembly. Grab the retaing ring and turn it. Then remove the head light but save the ring and unplug the wires. IMPORTANT NOTE: Do not touch the glass part of the new head light. How do you change the headlamp assembly on the passenger side of a 1994 Town and COuntry van, not the light bulb itself, the entire assembly?
forget about changing just the boot-its easier and faster to change the whole axle assembly and you dont need all of the special tools