Should be located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator Remove this housing Note how thermostat is installed in housing Clean both surfaces Replace thermostat and gasket Replace housing Re-fill coolant slowly to prevent an airlock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level
Where is the thermostat on a 1997 chevy suburban and how do you change it?
take the water outlet off the top of the engine and the thermostat should be right there
They were not used in 1986
taking for grant this 2000 suburban has a 5.3 eng in it. the thermostat would be located on the water pump, behind the water outlet that the upper hose connects to
129.5"
To change the thermostat on a 1986 Volvo 240DL, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then locate the thermostat housing, which is typically at the end of the upper radiator hose. Remove the housing by unscrewing the bolts, take out the old thermostat, and clean the surfaces before installing the new thermostat with the correct orientation. Reassemble the housing, refill the coolant, and reconnect the battery.
The thermostat may be stuck open
195 degree
Pictures and instructions are found here: http://www.padandwheels.com/mr2/thermostat/thermostat.html
How do you change a tire on a 2000 chevy suburban
how do you change an alternator on a 2003 chevrolet suburban?
how to change heater core in 98 suburban