take off the wheel
take off the caliper
pop the dust cap off the center of the hub
pull out the cotter pin from the castle nut
remove the nut and washer behind it
pull the hub/rotor assy off the spindle
remove the outer wheel bearing and race if damaged
turn rotor/hub over
with a small flathead screwdriver, pry off the rear bearing seal
pull out the inner bearing and remove race if damaged
clean out all old wheel bearing grease and dirt/debris
pack new wheel bearings PROPERLY with high temp bearing grease
install new inner and outer races if required
install inner bearing and replace bearing seal by gently and carefully tapping it in place with a small hammer
flip hub over
slide hub onto spindle
slide new outer wheel bearing into center of hub
slide washer onto spindle
install nut tightening to the point that the rotor spins with some drag, but not excessive.
install new cotter pin through hole in spindle and slot in the castle nut. you may have to loosen or tighten the nut a slight bit to line up the hole and slot properly.
tap dust cap back o
install caliper
install wheel
torque your lug nuts!!
No
how due you vhange a inner and outer tie rod on a 2001 Chevy Monte Carlo
There is no such thing as a 2008 Monte Carlo, so the answer would be no.
No
Water pump removal chevy monte carlo 3.8
Yes
you have to change the ring and pinon gars
There will be no 2007 Chevy Monte Carlo. The Monte Carlo has been discontinued and 2006 was the last production year. There are 2007 Monte Carlo's. They may have been made in 2006 but there are 2007 models.
You have to buy entire hub assembly. Easy to change and also wheel speed sensor gets replaced as well. (ABS or traction control light will go out)
Where is the oil sending unit at for a 2005 chevy monte carlo
How do i replace the purge valve on a 1999 Chevy Monte Carlo
Chevy