answersLogoWhite

0


Best Answer
Copy

Remove the serpentine belt, pull the radiator fan "shroud", remove the 4 bolts holding the radiator fan clutch to the water pump shaft, find and remove the bolts that hold the water pump to the block. It's often beneficial to purchase the replacement water pump BEFORE you remove it, so that you can see where all of the bolts are.

Durng the process, you'll need to remove the occasional radiator hose and other stuff that gets in the way.

User Avatar

Wiki User

βˆ™ 2011-09-13 00:29:56
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Will a 1996 Chevy Suburban transmission work on a 1995 Chevy Suburban engine?

Yes it will, there the same.


Where is rollover switch 1996 Chevy Suburban?

Chevy did not use them on there trucks.


Does a 1996 Chevy Suburban have air condition filters?

No


Where is the coolant temperature sensor on a 1996 Chevy suburban?

To the left of the thermostat housing, It screews into the intake water jacket.


Will a 1997 Chevy Suburban rear end fit a 1996 Chevy Tahoe?

yes


Will a 1996 Chevy 4x4 Silverado transmission fit into a 1996 Chevy 4x4 Suburban?

Yes it will fit right in there. No problems.


Will a 1993 Chevy suburban trans fit in a 1996 gm suburban?

Yes it will if there both 4x4 Transmissions.


How many 12 subwoofers can fit in 1996 Chevy Suburban?

36


What type of car did biggie die in?

A green 1996 Chevy suburban


Wilwill the hood bumper grille and fenders off a 1993 Chevy Suburban work on a 1996 Chevy Suburban?

the hood and bumper and fenders will, the grille is slightly different


How much does it cost to paint a 1996 Chevy Suburban?

9 million dollars


What year engines will fit in a 1996 Chevy Suburban?

1996 to the early month of 1999 will all fit with no problems.


How do you replace the multifunction switch on a 1996 Chevy suburban?

my husband says there isn't one


How many quarts of oil needed for a 1996 Chevy Suburban?

About five quarts should do it.


Does your 94 Chevy Suburban come with a mass air flow sensor?

NO. Not until 1996


Where is the voltage regulator at on 1996 Chevy Suburban?

It is built into the alternator. It is all 1 unit.


Is the fuel pump in or out of the gas tank on a 1996 Chevy Suburban?

It is inside of the fuel tank.


How do you change the pittman arm on a 1996 Chevy Suburban?

You need a wedge tool to separate the arm from the main steering rod , then unfasten the two bolts and it is off .


Is there a fuel filter by the carburetor on your 1996 Chevy Suburban?

No, a 1996 is fuel injected not carburetted. The fuel filter is along the frame.


On a 1996 Chevy Suburban the brake system incorporates a dump valve What does this dump valve do and or where is it?

The brake dump valve on a 1996 Chevy Suburban is used for bleeding the brakes after new brake pads are installed. It is located on the master cylinder for each brake.


How many miles can you expect from a 2000 Chevy Suburban Would it be worth buying used with 100000 miles on it?

i have a 1996 Chevy suburban with 226,000 miles on it and it runs great so you make that decision


Why would a 1996 Chevy Suburban have no spark and no fuel?

Need to replace the ingnition module in the Distributor.


How many gallons of gas does a 1996 Chevy suburban 1500 4wd hold?

42 gallons.


How to replace disc pads on 1996 Chevy Suburban?

what kind of wrench to remove brake pads


Where is the speed sensor located on 1996 Chevy Suburban?

It is located on the left rear of transfer case.