0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Can you put grease in the wheel bearings of a 1989 Topaz?
You must remove the wheel bearings, inspect them, repack them with grease, and install them back in the vehicle.
Replace front wheel bearings on a 1989 Toyota Corolla?
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
What would cause my new to me Mazda 1989 929 to vibrates while accelerating and braking?
Wheel hubs or bearings or could be the CV shafts.
How do you change wheel bearings on a 1991 Plymouth Acclaim?
Remove the center bolt for the C/V joint... remove rotor and brake caliper, there is 4 bolts that holds it on, remove the bolts and it will come off and install in reverse order. ============================================================== This isn't true for say, a 1989 Acclaim which has the front wheel bearings pressed it, as well as held in by 3 bolts into the spindle. This I know as Ive replaced both my front hub (wheel bearing) assemblies on my 89 Acclaim LX. ~Technologic80
When was Laser Ghost created?
Laser Ghost was created in 1989.
When did Laser Ghost happen?
Laser Ghost happened in 1989.
When was Laser Quest created?
Laser Quest was created in 1989.
How install a new bearings on a 1989 Ford Tempo?
We need to know which bearings you speak of, there are many.
What would you do about a bad car bearing the car is a 1989 Ford Tempo GL?
there are MULTIPLE bearings in a car...wheel bearing, engine bearing, ect. you need to be more specific.
How do you replace front wheel bearings on a 1989 Taurus?
you need to take the spindl off then you got to press the hub out then look for a snap ring then press the bearing out and repet backwards
When was Laser Mission created?
Laser Mission was created in 1989-11.
Can front wheel bearings on a 1989 Topaz be repacked with grease?
No. You have to replace the bearing. If your local shop is good, takes less than 1 hour labor plus the cost of the bearing.
