answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you check amp reading on a 12volt cooling fan?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What minimum fuse rating is needed for a 12volt curcuit with a 36 watt bulb?

36 watt / 12 volt = 3 amp


What power source is needed for 26 small 12volt incandescent 50ma lights?

They could be run in parallel from a 12 v 1.5 amp power supply.


Can a 4 ohm bridged car amp handle a 2 ohm speaker with proper amp cooling?

nope


What does RC mean on 12volt car batteries?

Reserve Capacity. The number of minutes a battery can maintain a useful voltage under a 25 amp discharge. Reserve capacity is often a truer test of battery life than amp hours.


How do you divide 12 volt 5 amp in 4 cameras of 12volt 0.5 amp?

What determines the current is the load. So voltage is the important factor. The voltage is the same. So you only conect up to ten cameras and the current is ok. They will work fine.


How do you hook up an amp and sub woofer up to a stock radio in a 1996 firebird?

cut the back speaker wire going to one of the rear speakers.. take the pos and neg into the amp.. if the amp only takes RCA inputs you will need to buy a line level converter.. turns pos neg into RCA.. also you must wire up a switch for turning the amp on.. just a 12volt source works


Where are the cooling fan relays in a 1998 Mercury Tracer?

On a 1998 Mercury Tracer, the cooling fan relays are located in an engine compartment box. The compartment box should be labeled 'Cooling Fan 40 amp.'


Function of fuse 7 Volvo 1987 740 turbo?

7-25 amp Electric Cooling Fan


If an 100 amp fuse is replaced by an 80 amp fuse will it cause the check engine light to come on?

No, this is not monitored.


What could be causing your 2000 ford Windstar battery to not hold a charge?

it could be a bad battery or else something is drawing power from the battery get the battery checked at a auto parts shop most shops will check your battery for free while you are at it get them to check the alternator is charging properly also once you know its not the battery or alternator at fault put an amp meter in series between the battery positive and the positive wire of the vehicle with everything switched off you should only get a reading of well below 1 amp(because of clocks and radio memory etc there will always be a small draw) anything near or above one amp is too much of a draw if this is the case start removing fuses one at a time replacing each one as you go until you find one that causes the amp reading to drop to well below one amp then check what the fuse is for and it should lead you to the fault


Wiring Color codes for kenwood kdc-mp5032?

RED-12VOLT YELLOW-MEMORY 12VOLT WHITE-FRONT LEFT+/WHITE WITH STRIPE- GRAY-FRONT RIGHT+/GRAY WITH STRIPE- GREEN REAR LEFT+/GREEN WITH STRIPE- PURPLE REAR RIGHT+/PURPLE WITH STRIPE- BROWN-MUTE ORANGE-ILLUMANATION BLUE-REMOTE(AKA)AMP TURN ON BLACK-GROUND(NEG.)


How does the amount of current in a home circuit differ from the amount of current in a reading lamp?

The current in a reading lamp would be a small part of the total current in a home. For example, a home may have 100 amp service, while a reading light may draw less than 1 amp, so about 1% of the total.