0
Use a leak-down tester in the suspect cylinder to see if the valve is sealing.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Can you find out if your pistons hit your valves when the timing belt snaps or do you have to put new timing belt on first?
You can do a cylinder leakage test to check for bent valves.You can do a cylinder leakage test to check for bent valves.
How do you check for bent valves on 2000 Daewoo leganza?
do a compression check on each cyl.
What are signs of a belt jumping time on a 2003 Chrysler Sebring?
Check engine light, low power, no start, runs rough, bent valves,Check engine light, low power, no start, runs rough, bent valves,
How do you check the valves on a 1987 Caprice 305 V8 that jumped time?
If you are worried about bent valves DON'T That year engine will not bend the valves when the timing chain goes bad.
How do you repair bent valves in a 1.8T AWP engine?
Replace the bent valves with new ones. Several places carry them. Be prepared it is a very in depth job. Be sure to check the pistons to make sure they aren't too damaged from the valves coming into contact with them.
Is the ford 4.6 liter motor an interference motor?
Yes it is. I know this by experience. Timing jumped and bent the valves
What happens when timing belt breaks on a 2004 dodge neon?
Bent valvesBent valves
How do you know if the valves are bent on a 2001 dodge stratus sedan?
Remove the spark plugs and check the compression in the cylinders, low to no compression will indicate a bent or stuck valve
If the valves on a car aren't bent then would the car still fail a pressure check on the valves after timing belt snapped?
Timing marks are not lined up correctly.
What are possible causes for bent valves?
One of the most common reasons for bent valves is a broken timing chain or belt.
What causes a bent valve?
The main cause for bent valves is a failure in the timing chain or belt. When the valves and pistons are not exactly in sync, they can collide.
Do you need to have the valves changed when the timing belt breaks?
If the valves bent, then yes.
