0
What else can I help you with?
Where is the oxygen sensor located in a Ford Contour 2000?
go to autozone they will check it free
What is code P0135 Ford Contour?
Oxygen sensor 1. In exaust manifold.
How do you check if the ABS sensor is working on a 1999 Ford Expedition What can you do?
how do you check the abs sensor on a 1998 contour
How do you check oxygen senson on a 99 ford contour?
Osiliscope or a scanner. You need to see the wave pattern to check it properly.
Where is the range sensor in 2000 Ford Contour?
it is located where the transmission is and is very easy to change. on a 2000 ford contour that is.
If both the idler air sensor and the oxygen sensor shows malfunctioning which should be replaced first on a ford contour 95?
First, change the oxygen sensor and the air filter. Clear the codes and see if the idler air sensor code comes back.
What is code P0141 on Ford Contour?
Heater condition (Heated oxygen sensor-bank 1 Sensor 2) Probable cause 1 Faulty O2 sensor (H02S12 (Bank 1 Sensor 2)) It's the O2 sensor after the cat 2 Poor connection at oxygen sensor 3 Check circuit fuse (fuse box under the hood by the battery #13 fuse)
Where are oxygen sensors located on a 1996 ford contour?
wher are the oxyegen sesors located on a1996 ford contour
1999 ford contour will crank but wont start it has power to the coil but no spark to the wires?
The first thing I would check is your crankshaft position sensor
Where are the Bank 1 Sensor 1 oxygen sensor on a 1998 Ford Explorer?
Where are the Bank 1 Sensor 1 oxygen sensor on a 1998 ford explorer?
Where is the coolant temperature sensor on a 1997 ford contour?
it is threaded into the thermostate housing.
How do you change the oxygen sensor on a Ford Aspire?
To change the oxygen sensor on a Ford Aspire, first, ensure the vehicle is turned off and cool. Locate the oxygen sensor, typically found on the exhaust manifold or in the exhaust pipe. Disconnect the sensor's electrical connector and use an oxygen sensor socket or wrench to unscrew the old sensor. Install the new sensor by threading it in and reconnecting the electrical connector, then start the vehicle to check for proper operation.
