dipstick or ther could be a litte oil window on rt side of the bike or there is a little screw on the right by the foot peg remove it oil cap and plug drain all the oil put the drain in start fillng when it starts trickling out by the foot peg its full put screw in and your done
on my rmx 250 1999 there is clear glass on motor thats your oil level
there will be a bolt on the right side by the water pump. take that bolt out and drain then fill it up till oil comes out the bolt..
You can't chaeck the oil level in a newer 2stroke you have to just change the oil and put the right amount back in it.
you have to remove the oil check bolt. its about half way up on the clutch cover and is just a regular bolt. remove it...if oil leaks out, the level is good. if no oil comes out, visually inspect it and see if you need to add more in...most likely you will. Fill the crankcase until oil leaks out of the hole where the oil check bolt was. At least this is how i do it for my 04 yz125..
The factory specs for a 2004 Honda vtx 1300 list the oil capacity at 3.9 quarts. Check the oil level to keep from overfilling.
6 quarts, normally, but you should always check the level after filling it.
The 2004 Ford F-250 owners manual shows : 6.0 quarts ( 5.7 liters ) with oil filter change
how do i check oil level on Mercedes c240 2001
Valve clatter? Check oil level and pressure? Fuel mixture?
The 2002 Ford F2 50 rear differential has and oil capacity of 5.5 quarts. You can check the oil level through the oil fill hole.
The manual that comes originally with vehicle explains how to check oil level .......no dipstick it is checked electronically on the dash using the"buttons" on the left side of the steering wheel
250