How do you check the transmission fluid level in a 2003 Mercury Mountaineer?

Answer 1

You have to take it to the dealer there is no way for you to check it

You can check the Transmission Fluid, there is a little window on the side of the transmission on the drivers side that shows the fluid level and you can also add transmission fluid on that same side. They just tell you to take it to a dealer so they can make more money!

Answer 2

Lift the hood, and on the \drivers side, towards the windshield, you will see a small tank with a black screw top lid. if you look close, on the outside of the tank, you will see a min and max lines.

Answer 3

First, unscrew the cap on the brake fluid reservoir. This is usually located on the master cylinder under the hood. Once the cap is unscrewed, fill the reservoir with fluid, and screw the cap back on. Pumping your brakes a few times with the car on before driving will help assure proper brake pad placement against the rotors.

Answer 4

The transmission does not have a dip stick. There is a special tool needed to pump transmission fluid into the transmission.

Bad news, transmissions on these trucks go out so often they are kept in stock at major transmission service centers.

Answer 5

The cavalier will have a brake fluid reservoir on the drivers side firewall. The reservoir has a screw on cap to allow access to add fluid.

Answer 6

There are two plugs on the rear side of the transfer case. One upper and one lower. These are the drain and fill plugs.