0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Do you have to drop the tank to get fuel sending unit out of 1997 olds lss?
yes
How do you locate and replace fuel sending unit on 1997 olds aurora?
The fuel sending is located in an access panel under the carpet in the trunk. It is actually part of the fuel pump. Im not quite sure how to replace it but you can get one from a junkyard for 100$ with a 90 day warranty
Where is the 1998 olds fuel sending unit?
in the gas tank
Where is the fuel pump 1997 olds regency?
Mounted on top and inside the fuel tank.
How do you install fuel pump on olds achieva 1997?
You buy tools and install it!
Where is the fuel sending unit located on a 1999 olds Alero 4 cylinder?
It is part of the fuel pump module inside the fuel tank. I think the only answer is to replace the entire unit.
97 Olds 88 fuel gauge brokenany ideas?
You got to change the fuel sending unit which involves dropping the fuel tank , aint really a bad job if you have a lift
How do you reset the fuel gauge needle on a 1998 olds?
There's no way to reset this. If it's out of range or doesn't work at all, check wiring going from fuel sending unit inside the gas tank up to main harness. The fuel sending unit may just be worn out and need to be replaced.
Where is the fuel pump relay switch located in a 1997 Olds 88?
pass. side panel behind the glove box
Does a 1998 olds intrigue have a fuse for the gas tank floater?
I believe one fuse protects all the gauges. If only the fuel gauge stopped working I would suspect the sending unit in the fuel tank is at fault.
What do you do if the fuel sending unit does not work in your 2001 Olds Intrigue?
Well, it's retroactive, but you should have bought a Ford. Seriously, the only thing you can do is take it to a certified shop and have it replaced.
How do you test the oil pressure sending unit on a 97 olds achieva 2.4 l engine?
You can test your 1997 Oldsmobile 2.4 liter engine oil pressure sending unit with a diagnostic tester. The diagnostic tester is the most reliable way to make sure your sending unit is working properly.
