answersLogoWhite

0


Best Answer

You should not clean an internal combustion engine unless you are going to tear it down, using solvent to break up sludge will deposit it in the oil pan, clog the oil pump pick up and you will then loose oil pressure leading to engine failure. If you still want to do this you must remove oil pan and oil pump pick up and clean after de-sludge. Don't trust this repair to just anyone. Know your mechanic.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you clean inside the engine on my ford windstar 1996?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the inside fuse box on a 1996 ford windstar?

On a 1996 Ford Windstar : Under the dash on the drivers side , not too far from the inside hood release


What type of oil for 1996 ford windstar?

( 5W-30 ) is the preferred engine oil , according to the 1996 Ford Windstar Owner Guide


Where is the oil pump located on a 1996 ford windstar?

3.0L - Bottom of engine mounted on the block, inside the oil pan. 3.8L - It's what the oil filter is screwed onto.


Were is cylyder 1an 4 on a 1996 ford Windstar?

On a 1996 Ford Windstar , V6 engine : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver


Need emission diagram for 1996 Ford WindStar 3.8L engine?

Emission diagram for 1996 ford thunderbird 3.8l


What vehicle gets a penske pa7774 air filter?

1996 Ford Windstar - V6 engine


Is a 1995 windstar 3.8 engine interchangable with 1996 aerostar min van?

Not even close


Does a 1996 ford Windstar have timing belt or chain?

The 3.0 or the 3.8 engine uses a chain.


I have 1996 ford windstar with a 3.8 liter engine it had a blown head gasket so i got it replaced it was running fine but now it just clicks and the belt and pulleys won't turn what could it be?

Check the 1996 Windstar's starter first. If the starter is working but it cant turn the motor, take a ratchet and turn the crankshaft by the front bolt. If the crank wont turn over then something inside of the engine has seized up.


Are 1996 Ford Explorer engines compatible with 1996 Windstar engines?

No , A 1996 Ford Explorer is either rear wheel drive or 4x4 capable or ( All Wheel Drive , available with V8 engine only ) A Ford Windstar is a front wheel drive vehicle


What is horsepower on 1996 ford winstar?

On a 1996 Ford Windstar : The 3.0 liter V6 engine is rated at ( 150 horsepower ) The 3.8 liter V6 engine is apparently rated at ( 200 horsepower )


How do you replace the GEM module on a 1996 Ford Windstar?

The GEM in a ford windstar is located up inside the dash, above and to the left of the gas pedal. it's held in with a single bolt.