0
The GEM in a Ford Windstar is located up inside the dash, above and to the left of the gas pedal. it's held in with a single bolt.
What else can I help you with?
Replace freeze plug on a 1998 ford Windstar?
Replace freeze plug in a 1998 ford windstar ?
What type of oil for 1996 ford windstar?
( 5W-30 ) is the preferred engine oil , according to the 1996 Ford Windstar Owner Guide
How do you replace the gem module on a 1995 windstar?
To replace the gem module on a 1995 Ford Windstar, first disconnect the negative battery terminal for safety. Locate the gem module, which is typically found under the dashboard on the driver's side or near the fuse box. Remove the screws or bolts securing the module, disconnect the wiring harness, and then install the new module by reversing the process. Reconnect the battery and test the vehicle to ensure proper operation.
Do you need to replace your abs module on your Ford 2002 Windstar to keep your normal brakes working properly?
No. Your normal brakes will still work even if the ABS Module is bad. You will however have no ABS function.
Where is the inside fuse box on a 1996 ford windstar?
On a 1996 Ford Windstar : Under the dash on the drivers side , not too far from the inside hood release
Where is located the sensor for the door opener on ford windstar 2002?
electronic module
Where is the tachometer wire on a 1996 Ford Windstar GL?
i dont know whwere is the tachometer wire of 2001 ford windstar
Replace rear side window 99 ford windstar?
where can i buy a side window for my 99 ford windstar lx
How do you replace the evaporator in a 99 Ford Windstar 3.8L?
I don't know how to do it, but the dealer is charging me $2075.00 to replace it on my 2000 Windstar!
How heavy is the 1996 ford windstar sport van?
3800lbs
Were is cylyder 1an 4 on a 1996 ford Windstar?
On a 1996 Ford Windstar , V6 engine : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
How do you replace a front electronic module on a 2001 ford windstar?
To replace the front electronic module (FEM) on a 2001 Ford Windstar, start by disconnecting the negative battery terminal to prevent electrical shorts. Remove the dashboard trim and any necessary panels to access the FEM, typically located behind the glove compartment. Disconnect the wiring harness from the module, unfasten any mounting screws, and carefully remove the old module. Install the new FEM by reversing the steps, ensuring all connections are secure before reconnecting the battery.
