If the car is a collector I would pay a good body man
to "buff" the paint
It is made out of plastic.
there is a dyi on the net, but bumper removal will be necessary, 2 bolts top of bumper in the rear cargo area 2 plastic bolts under rear section of bumper 2 plastic bolts under each corner of bumper 2 long screws by rear wheels going to top of bumper, then pull off
It is in the rear, right under the rear bumper. There is probably a plastic cover surrounding it.
InstructionsLift the rear of the Corolla using a floor jack. Jack up on the rear jack point behind the trunk, and place a jack stand under each of the rear pinch welds. Then lower the vehicle onto the jack stands.Pry the plastic rivets off the inner wheel liner with a flat-head screwdriver.Remove the bolts that hold the bumper to the bumper bracket and support.Pull the bumper off the bumper support.Mount the new bumper. Align the mounting holes on the back of the bumper's mounting bracket with the bumper support, and thread and tighten the bumper. Replace the plastic rivets that hold the wheel liner to the rear bumper.Remove the jack stands, and lower the car.
Neither, it is plastic.
right in front of rear bumper under a plastic splash pan.
how to remove 2013 passat rear bumper
The rear bumper is held in place with eight retaining bolts. Remove the retaining bolts and the rear bumper will come off. Reverse the process to install your new rear bumper.
Removing the Rear Bumper of a Passat...
www.50resto.comthey are about $25 or so. remember to order correct side.
in side the truck fold back both sides of the carpet take off the nuts on both sides then take out the rear tail lights and un fasen the top of the bumper there are plastic clips under the car that snaps to the rear bumper then finnaly take off the screws right behind the rear wheel note leave a couple of screws in the top so the bumper cover does not fall off ggood luck racer buck3
how to replace rear bumper brackets on a 2002 Nissan sentra