answersLogoWhite

0


Best Answer

While my recommendation is to completely replace the EGR valve, I will give you a website to order your part from, (I myself am shopping on the very website.) I will give you instructions on how to clean it, (If if it not completely corroded.)

Buy a EGR Valve gasket and a good carburetor cleaner. Have a bucket handy and a standard set of tools.

1. Disconnect battery.

2. Remove EGR valve.

3. With your finger, push on the diaphragm, it should move with ease or slight pressure. If not, replace it.

4. With carburetor cleaner, spray it over the valve and parts, to remove carbon build up. Make sure you spray into the bucket for easy clean up.

5. Check the gasket seal surface and ensure it is clean and ready for install.

6. Assemble EGR valve with new gasket, and install.

7. Test run and check for leaks.

And again.. I recommend buying a new EGR valve. It's only about 20 dollars.

www.rockauto.com

Click on the red button.

Search for your car, year, make and then go through your systems.. EGR valve will be under emissions.

The EGR valve you buy will come with a gasket

Recommend a HAYNES manual for you as well, for 15 dollars under Literature.

Its cheaper than to buy it in a auto part stores.. 24 dollars. :/

Let me know how it goes..

Kbillings@lsd50.navy.mil

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you clean the egr valve on an 1991 Isuzu rodeo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How many gallons does the fuel tank on a 1991 Isuzu Rodeo hold?

80 Liters


What fuel tanks are compatible with a 1991 Isuzu Rodeo 4x4?

1989 thru 2002 Rodeo, Passport, or Amigo 4x2 or 4x4.


Where is the ignition control module 1991 Isuzu rodeo 2.6l?

It is located under intake manifold towards the back. It is above the starter.


How do you shift to 4x4 on a 1991 Isuzu Rodeo?

Go onto a non-dry (such as grass or gravel or snow) and pull the lever from 2WD into 4H.


What motors will hookup to a 1991 Isuzu pickup with a 5 speed tranny?

you could mabye find a moter adapter for a Chevy v 6 or and of the Isuzu rodeo tropper mabye and the 2 or 4 weel drive Isuzu picups good luck


What size of motor does a 1991 Isuzu pickup have?

The engine is a 4zd1, 2.3L, 5 speed, rwd, 8 valve.


Why do the turn signals buzz and not flash but the hazard lights work on a 1991 Isuzu Rodeo if the bulbs and fuses are good?

Try replacing the turn signal flasher


Egr valve for Isuzu xs 1991compare to impulse 1991 dohc?

The 1991 Isuzu Impulse was offered in the 1.6L naturally aspirate (NA) and 1.6L turbocharged L4. The exhaust gas recirculation (EGR) valve is the same for both engines. The Standard Motor Parts EGR pn# is EGV1119. The OEM Isuzu part numbers# include 8943842120, 8970243880, 8970243890, 94384212 and 97024388.


What was the last year the Isuzu rodeo was made?

The last Isuzu rodeo Made was the 2004, I don't know why, but the single reason for me may be was the High and expensive cost of fuel, cause It was with only 6 sads cylinders and eats gas like an indigent when you say "there's free food on the Sirloin stokade..." in my recomendation the best model of Isuzu rodeo was the 1991 in line 4 cylinders with 2.6 I-tec Motor...good safer and cheap on gas and the best thing would be the car in standar transmission.


Can you clean the PCV valve on a 1991 Chevy Silverado Diesel 6.2 Liter or do you have to replace it with a new one?

Yes, you can clean the PCV valve. Take off the PCV valve and get a spray can of carb cleaner. Just spray into the valve and just enough to clean out any gunk that might be in there. You should hear it rattle when you shake the valve.


When was Isuzu Panther created?

Isuzu Panther was created in 1991.


When was Rodeo - song - created?

Rodeo - song - was created on 1991-08-12.