Want this question answered?
Your local motor spares shop should sell a Draper caliper retraction tool. Mine cost around £12 and does the job perfectly.
With an Easy-Out.
7mm
Not completly off, you will be able to lift the caliper off, but it will still be connected to the brake-fluid hose ;) then you pop off the pads and twist back the brake piston, and There you go :)
Brake jobs are not a job to be done without a Manual. Your life and the lives of others and the life of your Automobile depend on them.Please purchase a Manual and do the job correctly. Or Hire someone who can.Loosen the lug nuts by turning them counterclockwise 1/2 turn.Raise the Focus up and put it on jack stands. To do this, place the floor jack under the the Focus and jack up on the front jack point. Then, place the jack stands under the front pinch welds and lower the Focus onto the jack stands.Continue to remove the lug nuts and then remove the wheel.Remove the caliper mounting bolts holding the caliper in place.Lift the caliper off the hub assembly and secure it with zip ties to the coil springs above the brake assembly.Remove the brake pads. You may need to tap them out with a rubber mallet.Press the caliper piston back into the caliper. Place the face of a brake pad against the caliper piston and squeeze the piston back into the caliper using the c-clamp.Insert new brake pads and reassemble the brake system.**NOTES**Ensure the disc is clean and free of oils and dirtUse threadlocker on the caliper bolts to prevent them from losening while driving or heavy braking.Bleed the brake fluid lines to remove and air bubbles. Air could cause soft pedals or dead zones during braking.Put the wheel back on, finger tighten lug nuts. Lower the vehicle, and torque the lug nuts to 100 foot-lbs with a torque wrench.
The bolts that hold them on are threaded, the pistons are NOT. If they won't compress, or are stuck, you need new calipers. New calipers are cheaper than having them rebuilt. Try Pep Boys, JC Whitney, AutoZone, etc.
Remove wheels Re-install 2 lug nuts to hold rotor in place Remove flexible brake lines Remove caliper mounting bolts Slide caliper off rotor
It is pretty easy. The front pads have a special clip that has to be clipped on the caliper. The rest is just as easy as changing any car's front pads.
Use a "C" clamp.
how change brake fluid . i have ford focus lx 2000.ans how change air filter.
How do you remove the brake light cover on a ford focus
On a 2001 Ford Focus : The brake fluid reservoir is used for the brake and clutch systems