0
Router Configurations
A network engineer can enter commands via the CLI environment in several ways. The most common are:
* Console
* Telnet or SSH
* AUX port
While the engineer is in Privileged EXEC mode, it will allow him/her to make changes to the router such as configuring the FastEthernet interface. After the router is configured, the engineer should show the running configuration and copy the running configuration to the startup configuration periodically to save changes.
The importance of having a specific hostname would divert confusion during network configuration and maintenance. When accessing a device using Telnet or SSH, its important to make sure that a name is attached. If all devices remained with the same default name, you couldn't identify that the proper device is connected. By choosing and documenting names wisely, it is easier to remember, discuss and identify network devices. It is good practice to create the naming scheme at the same time as the addressing scheme.
Passwords are the number one defense against unauthorized access to network devices. Every device should have locally configured passwords to limit access. The IOS uses hierarchical modes to help with device security to allow different access privileges.
What else can I help you with?
Ho to install ios on router?
on the router then off the router your ios is install on the router then off the router your ios is install
Where is the router button on PS3?
It would be on your router. the PS3 does not have a router you have to buy one if you need a router
What comment are use to delete a routing protocols in cisco router?
No router eigrp <AS #> No router ospf <process ID> No router bgp <AS #> No router rip
What is a multiport connectivity device that directs data between nodes on a network?
the correct answer is router.
How can someone setup a router for a connection?
Begin by plugging in the router and pushing the power button. Next, connect your internet modem to the router and your computer to the router. Finally, open the router's administrative tool and log in to the router.
Which command enables rip on a router?
A(config)# router rip A(config-router)# passive-interface S0/0 B(config)# router rip B(config-router)# network 192.168.25.48 B(config-router)# network 192.168.25.64 A(config)# router rip A(config-router)# no network 192.168.25.32 B(config)# router rip B(config-router)# passive-interface S0/0 A(config)# no router rip
Why does your PS3 disconnect your router?
It is your router that disconnects the PS3 and not the PS3 that disconnects the router. Set the router to always on for internet connection, your router is disconnecting when it is not being used by the PS3 for the internet
Where is the router on a PS3?
The PS3 does not have a router. It can go online with an ethernet cable connected to a router or modem or with WiFi from a wireless router or modem
What is the total amount of RAM on the router?
A router does not have RAM. A router distributes data. The router does not hold data nor does it process data.
What is the difference between g router and ah n router?
Indoor range: 802.11g router approx. 38 m; 802.11n router approx. 70 m Outdoor range: 802.11g router approx. 140 m; 802.11n router approx. 250 m. Amount of streams: 802.11g router 1; 802.11n router 4 Max throughput per stream: 802.11g router approx. 72Mbs; 802.11n router approx. 150 Mbs Operating frequency: 802.11g router 2.4 GHz; 802.11n router 2.4 and 5 GHz
Are IP address' assigned to the router or the location of the router?
the router is assigned an ip address.
Is a Time Warner cable wireless router a wireless N router?
it says it on the router
