0
A(config)# router rip
A(config-router)# passive-interface S0/0
B(config)# router rip
B(config-router)# network 192.168.25.48
B(config-router)# network 192.168.25.64
A(config)# router rip
A(config-router)# no network 192.168.25.32
B(config)# router rip
B(config-router)# passive-interface S0/0
A(config)# no router rip
What else can I help you with?
What router prompt can you use the router rip command?
On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.
Which command or set of commands will stop the RIP routing process?
no router rip
How to use router rip command?
use of routerrip command
Which of the following would be the correct command sequence to enable RIP on Router B for all connected networks?
RouterB(config)# router rip
Which command or set of commands will stop an RIP routing process?
To stop an RIP routing process on a Cisco router, you can use the command no router rip in global configuration mode. This command removes the RIP configuration and stops the RIP routing process from running. Alternatively, you can use shutdown within the RIP routing configuration mode to disable RIP without removing its configuration.
What command will prevent RIP updates from C being sent to router A from router B and C network diagram?
To prevent RIP updates from being sent from router B and C to router A, you can use the command passive-interface on router B for the interface connected to router A. This command will stop RIP updates from being sent out that specific interface while still allowing updates to be received. Additionally, ensure that RIP updates are not configured on the interface connecting B and C if you want to restrict routing updates further.
How do you stop rip routing updates?
To stop RIP (Routing Information Protocol) routing updates, you can use the "passive-interface" command on routers to prevent the interface from sending RIP updates. This command can be applied to specific interfaces using the router configuration mode. Additionally, you can disable RIP entirely by removing the RIP configuration from the router or using the "no router rip" command. Finally, implementing route filtering with access control lists (ACLs) can also help control the propagation of RIP updates.
Which command correctly starts routing process in cisco router?
To start the routing process on a Cisco router, you typically enter the command router [routing_protocol] in global configuration mode, where [routing_protocol] could be protocols like rip, ospf, or eigrp. For example, to start the OSPF routing process, you would use the command router ospf [process_id], where [process_id] is a unique identifier for the OSPF process. This command enables the routing protocol and allows for configuration of related settings.
What command enables a DHCP relay on a Cisco router?
hal-loosi
Which two statements are true about the use of the debug ip rip command on a Cisco router?
The debug ip rip command displays RIP routing activity in real time. The debug ip rip command can be issued at the user EXEC configuration mode.
What command is used to stop rip routing updates from exiting out an interface but still allow the interface to receive rip route updates?
Router(config-if)#no routing
A network administrator enters the service password-encryption command into the configuration mode of a router What does this command accomplish?
This command enables a strong encryption algorithm for the enable secret password command.
