0
if by BUS you mean Frontside Bus, you dont need to configure anything, it is automatically configured when the computer is made
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How would to configure wireless properties on a workstation running Vista given that the workstation has a wireless NIC?
you configure by looking at your rear and you might find the light blinking on your NIC!
What information is needed to configure a NIC?
i.p address, sub-net mask and default gateway
Which bus type is preferred for NIC that will be connected to a fast Ethernet network?
USB bus
Does Wii Have an Ethernet Port Built In?
No. You must either get a USB adapter or use a Wireless connection.:)Another, more accurate answer.The standard Wii comes with a wireless NIC built in. You may need to configure the Wii and/or your wireless router to make it work.
What are the three general steps which are necessary for installing a network card and connecting a PC to a network?
Put the NIC in the PC, and install the NIC's drivers. Configure the NIC using Windows, so that it has the appropriate addresses on the network and the correct network protocols. Test the NIC to verify that the PC can access resources on the network.
The most popular expansion board NIC is one that uses?
PCI Bus
Which bus type should you use for a NIC that will be connected to a Fast Ethernet network?
PCI
How many network cards are wanted for make LAN and Internet connections?
A Network Interface Card, or NIC, is required for each computer on a Local Area Network, or LAN. Because older computers did not have the Universal Serial Bus, they had to have a NIC to be connected to a modem which was connected to the internet.
Which PC bus allows you to connect a NIC to your computer easily without powering off?
USB
Where do you go to configure your computers NIC to transfer data at 10 Mbps Where do you check the transfer data speed setting on a NIC?
This would depend on the operating system, but in Windows XP, you go to Control Panel, Network Connections, double click on the NIC (Network Interface Card) in question. Click the Configure button, then click the Advanced tab. Be careful when changing speeds of the NIC. Most switches are set to Auto. Sometimes when you change the NIC properties you will not be able to communicate. Sometimes powering off the device will fix that, sometimes not. Also, you need to match duplex settings as well. 10mbs should be set to half duplex, 100mbs should be set to full duplex. The switch should be set as well. I have seen it that the switch was set to auto and changing the device would not work until the switch was set. Older printers were usual culprits.
Switches ans NIC's works at layer?
nic work on data link layer which is layer 2
What bus type allows a NIC to be attached externally?
USB bus allows a Network Interface Card (NIC) to be attached externally to a computer or other device. NICs can be connected via USB ports on a device, enabling network connectivity without the need for internal expansion slots.
