0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Your computer say tftp no reply from server?
Either from below is possible:Link to TFTP server is temporarily damaged.Link to TFTP server is permanently damaged.TFTP is shut down.
Why is it important to configure and enable iptables on your fedora Linux server?
Because if you don't, the internet will not work properly. "iptables" is the method used to configure the built-in firewall in the Linux kernel.
From what location can a router load the Cisco IOS during the boot process?
TFTP server, Flash
What does the command copy flash tftp accomplish?
it copies the ios FLASH to TFTP SERVER
What should be done before performing a backup an IOS image to a TFTP server?
Options are: A) Make sure the TFTP server is reachable across the network. B) Check the password authentication for TFTP access. C) Assure that the TFTP server has enough hard disk space for the IOS image. D) Make sure that the TFTP server can store text files. E) Adjust the maximum IP packet size to speed up transfer F) Verify that the TCP connection to TFTP server is ready. Anyone? Answer is all the above.
What is TFTP Server 9.1 used for?
"The TFTP server is used for webpages that have a maximum server load. It makes it easier for your webpage to get a lot of hits without going down, and keeps it secure."
What command and prompt are used to save a router configuration file to the TFTP server?
RouterC#copy running-config tftp [copy run tftp]
What command and prompt used to load a save configuration file from the TFTP server?
RouterC#cpoy tftp running-config [ cpoy tftp run ]
What port number does the TFTP server use to accept request from client?
By default a TFTP server will accept connection requests on UDP port 69.
What is the effect of command copy running config tftp?
This command will copy the running configuration (located in RAM) of a Cisco device to a TFTP server. After executing the command you will be prompted for further information about the TFTP server (Server Address, file name, etc.).
What is the purpose of using the copy tftp flash command on a router?
What is the purpose of using the copy tftp flash command on a router? to back up the current IOS image to a server to restore the IOS image from a server to back up the router configuration to a server to restore the router configuration from flash
What is accomplished by the command copy tftp running-config?
This command will allow you to copy a configuration from a TFTP server to the running configuration of a Cisco device. When you issue the command you will be prompted for further details about the TFTP server. The new configuration will replace the active one (or running configuration) and make any necessary changes.
