A: Add the proper resistor in series with the LED. What resistor? Simple 10volts source minus the LED source divided by the 20ma current that should be flowing gives you the resistor 10-1.8=8.2/.02=900 ohms. The 1.8 can be anything it is up to the LED voltage drop. LONG LEAD IS POSITIVE SHORT IS NEGATIVE SINCE IT IS A DIODE
farnt
Yes it will - graphite is a conductor.
BATTERY + - | | | | | ----------------------LED-----------LED---------LED---------LED------------ | | | | | | | | | | | | | | | | | | ------------------------------------------------------------------------------------------ No the above is a series circuit it would also need a ballast resistor so not to cook your LED's. This is a parallel circuit- +---------- ---- ---- ---- | | | | LED LED LED LED | | | | - ---------- ---- ---- ---- It is best to give each LED its own resistor.(not shown) For some reason when I click save it removes the spaces, ASCII characters have never been good for representing circuit diagrams.
Sure. If you want sound when the circuit is energized, use a buzzer. If you want a visual indication when the circuit is energized, use an LED.
To design a circuit so that lights can be turned on and off separately, we connect the circuit in parallel.
light up when forward biased
It probably means LED leads, which are the two wires sticking out from the LED that connect it to the circuit.
Connect an LED, two AA batteries, and a resistor of around 100-150 ohms, all in series.If the LED doesn't light, then turn either the LED or the batteries around in the circuit.
Actually, if you connect the above described LED to 220 V, it will immediately burn out then the circuit will be "open" and the resistance will be "infinite".
Yes it will - graphite is a conductor.
How do you connect an ammeter to a circuit?
Mood lighting in the car can be done by connecting LED lights to the rest of the battery circuit. Disconnect the negative cable and connect the LED light connector to the circuit that leads to the rear lights.
how connect a variable resistor to circuit
BATTERY + - | | | | | ----------------------LED-----------LED---------LED---------LED------------ | | | | | | | | | | | | | | | | | | ------------------------------------------------------------------------------------------ No the above is a series circuit it would also need a ballast resistor so not to cook your LED's. This is a parallel circuit- +---------- ---- ---- ---- | | | | LED LED LED LED | | | | - ---------- ---- ---- ---- It is best to give each LED its own resistor.(not shown) For some reason when I click save it removes the spaces, ASCII characters have never been good for representing circuit diagrams.
A volt can not be connected to a circuit.
If a circuit requires an IR LED, it requires an IR LED, there is no replacement. If a circuit does not require an IR LED, there is no need to look for a replacement.
connect ammeter in series with load.
it is necessary to connect both the terminals of a battery to a circuit for current to flow through it..!!