Just hook it up like you would hook it up to your car
+ to + and - to -
Do you mean that you can not charge it with a battery charger or the mower will not charge it while it is running? If you can not charge it with a battery charger and you are sure that the charger works then the battery is bad. These type batteries are only good for a couple years. If the mower is not charging the battery it could be a number of things.
Check voltage on battery 12 volt you should uses a 12 volt 2 amp battery charger connect red (positive) to the + side of battery and the black (negative) to the - side of the battery.
Not sure if the question is what to charge the battery with or how to charge the battery. So, I will address both: A regular battery charger can be used. IF you are going to purchase one, you really don't need a top-of-the-line, expensive charger. A simple 2 to 6 amp slow-trickle charger will do the job. To charge the battery, connect the red charger cable to the positive battery post and the black charger cable to the negative battery post, then turn on the charger until the battery is charged. If necessary, clean the battery posts and cables before charging. The battery charger will have more complete details for charging the battery.
Not at all. A 35 amp charger is far too large to charge a lawn mower battery. Use a 10 amp automatic charger.
Depends on the output of the charger which you did not list. A dead battery can be recharged with a 10 amp charger in 3 hours.
they can be recharged by hooking jumper cables from a car to the mower or if the battery is fried you would have to buy a new battery for it Use a battery charger just like the one you use on an auto battery.
a trickle charger will not jump start anything,however if it is left connected long enuff, and the battery will take a charge, the mower should start. to jumpstart, a mower, you can use a car the same as you would jump start another car. just make sure battery in mower is 12 volt same as car
can a 12v lawn mower sealed battery be charged with 12v battery charger use on cars
A battery float charger is intended only to keep a fully charged battery from losing its charge. It will NOT work to charge a battery that is discharged or damaged. Check the voltage of the battery to be charged. Do not use charger if the battery voltage is less than 9.6 volts.
Provided the charging system on the mower engine is operational, a small amount of charging voltage will be supplied to the battery during use.
Yes. All of the negatives need to be connected together and connected to the negative terminal of the charger. Then connect the positives together and connect to the positive terminal of the charger. Make sure the batteries are fully charged before you start and you are using a 12V charger. You can start with one battery connected and add more batteries as you check that they are fully charged.
Yes, but it takes a very, very long time. The charging system on the riding mower is very low amperage. You would do much better charging it with a battery charger.