Want this question answered?
it is on the back driver side of the engine on top where the engine and bellhousing connect you will see 3 wires coming off the wiring harness at the bellhousing they connect to the cranksensor
It will have a plug to connect to the wires coming from the harness. This plug can be connected to the sensor with wires or sealed right into the sensor It will have an end that sticks into a hole in the engine. It may be directly held in the block or held in by clip but either way it will be held in by a screw or bolt.
no
usually there is about a foot of wires coming out of the sensor and then there is a clip that connects to another set of wires
the black wires are for the heater circuit, the blue and white are the sensor wires. the universal sensor probably wont work though, its best to bite the bullet and get the correct one from toyota.
The knock sesor is located, on your Isuzu 1290, at the front of the engine. The sensor screws into the engine. Wires connect the sensor to the senor light.
what do you mean connect? wire, or the whole sender
I think its the purple wire coming from the Oxygen sensor!
A manner that is good
Wow, try that one again.
This sensor is located on the air intake track. This sensor will only have two wires coming from itÊandÊthis sensor is also called the throttle body.
Power it. The sensor bar is really just a collection of infrared LEDs. With the standard sensor bar, just plug it into the back of the Wii console.