0
There's only 2 outer tie rod ends.Make sure you got the cotter pins out.Then get a longer wrench.if that don't do it heat them up red hot with a torch they'll come right off.if you're talkin about the studs stuck in the steering knuckle,Try whacking the knuckle where the stud goes in.or beat on the end of the stod if you are replacing it anyway.
What else can I help you with?
Did many 1984 trucks come with limited slip 12 bolt rear ends?
Most trucks in the 1980s did not come with 12 bolt rear ends. The most common was 14, but 10 bolt rear ends were also in evidence.
Why is there play in your steeringwheel on your vectra?
either your rack and pinion worm gear is worn out or you have bad inner-outter tie rod ends. turn the steering wheel back and forth and have a buddy watch the tie rod ends for play. replace as needed.
How the Vietnam war ends?
By NVA tanks over running South Vietnam's capital in April 1975.
What is a Bolt for a girder?
A bolt for a girder is a bolt that is cast in place with the cap. Therefore the bolt is concreted into the cap of the substructure of the bridge. The girder is then set on top of bearing pads, on top of the cap, in between the girder bolts. The bolts are there to keep the ends of the girders from moving side to side.
How a block mountain is formed?
When older rock ends up on younger rock When the Earth surface is pushed up along a crack or two.
How is fault - block formed?
When older rock ends up on younger rock When the Earth surface is pushed up along a crack or two.
Can a gm 8.8 bolt 3.73 gears fit in a 10 bolt?
No, GM 8.8-inch bolt 3.73 gears cannot fit in a 10-bolt rear end. The 8.8 and 10-bolt rear ends have different gear designs, sizes, and configurations, making them incompatible. If you're looking to change gears in a 10-bolt rear end, you'll need to use gears specifically designed for that axle.
What Are the parts of a leaf spring?
The eye(round ends of the main spring, that the bushing goes in), leafs, center bolt and rebound clips.
How do you know if your 10 bolt Chevy rear has c-clips?
All GM. rear ends have c- clips that hold the Axels in. Except 3/4 tons and up with full-floating rear ends.
How do you crack the code of where Jonah is going in the 39 clues?
you have to count the gate number from the destination. EX. 2nd in Tokyo = o the answer ends up being Croatia
How you can install lock wire on the bolt heads?
To install lock wire on bolt heads, first thread the wire through a hole in one bolt head, then twist the wire around itself to secure it. Next, thread the wire through the hole in the adjacent bolt head and wrap it around that bolt head as well. Finally, twist the ends of the wire together tightly to prevent the bolts from loosening.
What are the torque settings of a Daewoo matiz 800cc main bearings and big ends?
what is the head bolt torque setting on daewoo matize
