It is a very tough disease . I will never suggest any patients with tubal blockage or hydrosalpinx to take a laparoscope. The surgery only solve problems temporaryly, cannot cure the disease radically. Tubal blockage and hydrosalpinx often recur after the laparoscope. That is because the inflammation in the pelvic cavity is still there.
Who knows,ask a doctor or somthin
Fuyan Pill is an effective Chinese medicine to treat gynaecological diseases. You Before place an order I suggest you contact a doctor to look for the best advice.
fluid
Tubal blockage caused by chronic inflammation, chlamydia infection and mycoplasma infection can be cured by proper traditional Chinese medicine.You can know more at the following website.Good luck! http://www.99eyao.com/english/disease49.htm
check for blockage in the lines.
Anterior segment (contains aqueous humor)
A hydrosalpinx is a descriptive term and refers to a fluid filled dilatation of the fallopian tube. The condition can be bilateral or uniateral, and the affected tubes may reach several centimeters in diameter. The blocked tube causes infertility, while incomplete blockage or adhesions often lead to tubal pregnancy. Tubal corrective surgery are mostly performed to fix this problem. Adhesions and blockage can be removed by this procedure. Unfortunately, however, pregnancy rates tended to be low as the damage of the tubes done by the infection is not treated. Further, ectopic pregnancy is the typical complication. Herbal medicine is one of the most popular alternative treatment for hydrosalpinx. fu yan pill produced by Dr. Lee, has been patented as a treatment for multiple gynecological conditions, which works on hydrosalpinx and can cure it after three to four months medication.
Ineffective pump, blockage in the lines.
Castor oil is not a cure for anything. It may help the body be generally stronger but would not specifically treat fluid on the lungs.
vesicle contain fluid and acne result from blockage of bilosebaceous unit .and inflammtion of bacteria
you may have a blockage on that line.
The same place that is used for filling for the front wipers is the same for the rear as well. If no wash fluid is getting to the rear section, you may have a blockage anywhere in the line. Many times the blockage will be in close range to the nozzle where the wash fluid comes out. Check for kinks in the line where cornering occurs. You may also want to check the where the split in the line is for its path from the front of the van to the rear, and remove the line to see that fluid will flow out from the split. This will help in knowing that the blockage is at the front, or that it is toward the rear.