answersLogoWhite

0

How do you cut dome light off on 1999 wrangler?

Updated: 8/17/2019
User Avatar

Wiki User

14y ago

Best Answer

Take out the fuse or replace door switch with aftermarket

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you cut dome light off on 1999 wrangler?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

2002 jeep wrangler rubicon with 52000 miles the engine light comes on and off and seems to cut out or miss just before light comes on?

Have it checked for codes. There will be a trouble code if the light is on.


Will a 1989 wrangler top fit a 2002 jeep wrangler?

no it will not the cut off i believe is at a 1996 then it goes 97-03


What solid figure would you get if you cut a sphere in half?

Dome


What will make the security light stay on in a 1999 S10 blazer it will start but will not stay running?

security light on 1998 s10 start but cut off


What jeans have a W on the back pocket that are boot cut?

Wrangler or Wayna.


Why does your dashboard light cut off when you turn on your headlights?

Try rolling the dimmer dial upwards , just right of the headlight toggle, just short of turning on your interior dome light. Otherwise it's a short somewhere. jr


Why would the car roof light not work after you had an alarm installed?

AnswerSure it could be, but not necessarily. Maybe the bulb burned out. Maybe the fuse blew? If your incapable of checking these out, take it back to the alarm installer and nicely explain what happened and they will probably take care of it even if they didn't cause it. Certainly don't accuse them since it may not be related.AnswerWHENEVER INSTALLING ALARM SYSTEMS ONE OF THE FIRST STEPS THAT THE INSTALLER SHOULD TAKE IS TO DISABLE THE DOME LIGHT DURING THE INSTALLATION. IT CAN TAKE SEVERAL HOURS TO COMPLETE THE INSTALLATION AND YOU HAVE THE CAR DOOR OPENED TRIGGERING THE DOME LIGHT TO TURN ON. THE LIGHT CAN DRAIN YOUR BATTERY. THIS CAN EITHER BE DONE BY REMOVING THE FUSE FROM THE FUSE PANEL OR BY REMOVING THE BULB FROM THE DOME LIGHT SOCKET. THE ALARM IS USUALLY SPLICED INTO THE DOME LIGHT SINCE ANYTIME A DOOR IS OPENED THE DOME LIGHT IS TRIGGERED TO COME ON. THIS MAKES IT EASY TO ALERT THE SYSTEM THAT THE VEHICLE DOOR IS OPENED. DANOWhen the alarm is installed, they splice into the dome light wiring as the last person said. This way when the door is opened and the dome light comes on the electric current acts as a trigger to set off the alarm. However when the doors are opened, they close a circuit on the negative side of the dome light. There is 12 volt power running to the light at all times. So the alarm has to be wired in on the negative side of the dome light as well. When they do this, only one wire running from the neg side is needed. It is possible that the installer cut the wire and wired the alarm in series and not parallel. What this means is that the alarm has been included in the electrical path for the dome light instead of just using the current.


What are the release dates for Short Cut - 1999?

Short Cut - 1999 was released on: USA: 12 April 1999 (Sundance Film Festival)


Where is the impact fuel cut off switch on a 1997 jeep tj wrangler?

does not have one.only fords


What are the wires under the hood of a 1999 dodge ram 1500 attached to the hood light other than the light power and ground I cut them and now my stereo doesnt work?

hood light might be the same fuse as radio


Can light cut material?

A laser can cut most anything. Light Amplification by Stimulated Emission of Radiation. Of course, this is not light in its natural state, but you can cut most anything, if not everything; with light.


How do you disconnect the air suspension light from a 1999 Lincoln town car?

cut the middle wrie on the shut off swith. 4from left or 4 from right