If your air bag light is on there is a problem. Have the Air Bag system serviced by a qualified service technician. Turning the light off will not solve the problem.
Your Car has a LCM (Light Control Module) and it sound like the relays are going bad. You will need a new LCM or have it rebuilt.
yes because i got 22 on mine. i didnt have to lift it or cut anything.
if it was me i go to junk yard fine your car and cut the radio wiers out then match them up
no just get lifts for the front spring sells at discount auto for 5 bucks for a 4 pk
If you have a hoist it would be easier, but, if you do not have then high on jack stands. There is a cut out in the front of the fuel tank under the car.
"Crown of Light" is evidently a modified brilliant round diamond cut patented in 2003 by Premier Gem Corp. Apparently, the diamonds weigh more than they might appear to weigh, and the cut is especially useful when cutting visibly included stones (I1), because the cut effectively hides the flaw from a 'face up' inspection. You can follow the link, below, to read more and to see a photo of a cut stone.
The fuel pump is in the gas tank. You have to remove the tank for this. Or, if possible on some models you can remove the rear bench seat, cut open the floor and change the pump this way. I don't know if the crown applies to this.
A passenger air bag can be dangerous for a kid in a child seat. The cut off switch allows the airbag to be temporarily disconnected for the safety of a child passenger.
When you say "crown cut" I think you are referring to a compound angle cut. A compound angle is 2 angles cut at the same time. In crown for instance you put the trim in the saw at a 45 degree angle, and tilt your saw blade at a 45 degree angle as well.
It can be driven but unless the airbag is stuffed back in or cut out it will get in the way while steering. Not to mention you won't have an airbag if you get into another front end collision.
Victoria R. Kasperski has written: 'How to make cut flowers last' -- subject(s): Cut flowers
I would suggest a 5 to 6 inch lift and might require you to cut the inside lip of the fender and quarter panels! 28's are like