answersLogoWhite

0

To disable the factory alarm on a 2002 Isuzu Rodeo, you can try using the key fob to unlock the doors, as this typically disarms the alarm. If you don't have the fob, you can manually unlock the driver's door with the key. Alternatively, you can disconnect the vehicle's battery for a few minutes to reset the alarm system. If the problem persists, consulting the owner's manual or a professional may be necessary.

User Avatar

AnswerBot

3w ago

What else can I help you with?

Related Questions

Diagram of fuel lines on bottom of a 1999 izusu rodeo?

need a 1999 izusu rodeo fuel lines diagram


Where is your blockheater on your izusurodeo2.3?

where can i find my block heater on my izusu rodeo engine 2.3


How do you disarm a factory alarm on a 2001 Isuzu Rodeo?

To disarm the factory alarm on a 2001 Isuzu Rodeo, insert the key into the driver's side door lock and turn it to the unlock position. This should deactivate the alarm system. If the alarm continues to sound, you may need to start the engine with the key to fully reset the system. Always refer to the vehicle's owner's manual for specific instructions related to your model.


How do you replace the blower motor in a 1995 Izusu Rodeo?

remove the glove compartment you'll see it.


How do you disable the alarm that won't turn off for 1999 Honda passport or izusu rodeo?

The alarm will go off if the keyless entry has quit working. the keyless entry and alarm module is behind the glove box in the right corner. There is no way to bypass this module. The dealership will charge you out the ass for a new one. But back to the point, the key will disable the alarm. When the alarm goes off when you unlock the driver or passenger door, lock the driver door and unlock it again with the key. It should go off the first time you unlock it, but if it doesn't, lock it and unlock it again. This should disable the alarm. Atleast it does on my Rodeo.


Where is the bank 2 o2 sensor on a 2004 izusu rodeo?

the bank 2 is on the driver side i got this info from an Isuzu mechanic


How do you reset the alarm system on a 1998 Isuzu Rodeo?

To reset the alarm system on a 1998 Isuzu Rodeo, first ensure that the vehicle's ignition is turned off. Then, disconnect the battery for about 10 minutes to reset the system. Reconnect the battery, and the alarm should be reset. If the alarm continues to trigger, check the owner's manual for additional troubleshooting steps or consider consulting a professional.


How can you change shift solenoid izusu rodeo 98?

The shift lock on the solenoid is located under the shift lever cover. When the brake is depressed it then unlocks the shifter of the vehicle. If this does not unlock the solenoid then it will need to be replaced.


What actors and actresses appeared in Wig Rodeo - 1997?

The cast of Wig Rodeo - 1997 includes: Tom Bliss as Factory Worker Jeff Charroux Kchris Degelsey as Factory Worker Kari French as Office Worker Curtis York as Office Worker


Why would a 2001 Izusu Rodeo jerk in gear and make a sound but then run fine for a few days after your restart it and also sometimes stall while stopped?

I had the same problem in my 98' rodeo and the tube running to the EGR valve was clogged, taking the EGR valve off and spraying carb cleaner down the tube unclogged it and it fixed the problem


Will parts from a izusu trooper fit on a izusu rodio?

Parts from an Isuzu Trooper may fit on an Isuzu Rodeo, as both vehicles share similar platforms and components, especially in models produced around the same time. However, compatibility can vary based on the specific model year and engine configuration. It's essential to verify part numbers and consult with a mechanic or parts specialist to ensure a proper fit.


What is the small small red light next to the Tail Gate Opener button on a 1995 Isuzu Rodeo?

IT'S THE ALARM LIGHT.