Want this question answered?
The power consumption of the led is very low and the life of LED bulb is high. Hence LED's are used as cost saving and energy saving measure and not hte conventional incadscant indicator bulbs. ...
Sure. If you want sound when the circuit is energized, use a buzzer. If you want a visual indication when the circuit is energized, use an LED.
light up when forward biased
current limiter.
It may work in several different ways, depending on the actual circuit used. As asked no better answer can be given than the circuit board alternately turns the current in the LED on and off.
An LED driver is a self-contained power supply that has outputs matched to the electrical characteristics of the LED or array of LEDs.
We probably can. You would need to provide the original circuit first, though. :D
Well, you don't really provide enough information to answer it right, but in general you would want to add another LED or replace the existing one with a brighter one. You can determine generally what kind of LED the existing circuit has by measuring the voltage across it and the current through it (either side, doesn't matter which). Then you could get an LED that can operate at the same voltage and that draws slightly more power. Be careful though, since the circuit may not provide enough power to run the new LED- you could potentially burn out the circuitry that supplies the power, if any. If you want to replace the LED with one that is a *lot* brighter, you'd be better off making a new power circuit and using the power through the existing LED circuit to turn on the power to your new power circuit.
a resister is to RESIST current flow....if the LED gets the full effect of the power supply, the LED will immediately blow out.
If a circuit requires an IR LED, it requires an IR LED, there is no replacement. If a circuit does not require an IR LED, there is no need to look for a replacement.
1. Relay Drive by Means of a Transistor 2. Relay Drive by Means of SCR 3. Relay Drive from External Contacts 4. LED Series and Parallel Connections 5. Electronic Circuit Drive by Means of a Relay 6. Power Source Circuit 7. PC Board Design Considerations
ghjfghjghjghjghj
The power consumption of the led is very low and the life of LED bulb is high. Hence LED's are used as cost saving and energy saving measure and not hte conventional incadscant indicator bulbs. ...
the function of an led is to give of light coming through an electrical circuit
Sure. If you want sound when the circuit is energized, use a buzzer. If you want a visual indication when the circuit is energized, use an LED.
In most cases the lights are in your odometer. There is an LED bulb behind each symbol and the LED is lit up because it is sitting on a circuit board. The circuit board gets its power from the car battery through a series of wiring and relays.
led to 250 watts bulb