repair modulator encoder dishes
To avoid interference
It is an electronic device on board a geostat satellite to receive uplink data and picture bits,amplifying it before converting it to a downlink freqency bit stream and sending it down to earth.
GSM 900: Uplink frequency: 890 - 915 MHz GSM 1800 : Uplink frequency: 1710 - 1785 MHz GSM 1900: Uplink frequency: 1850 - 1910 MHz
Uplink translates also to Upload - where you send data to another destination.
uplink frequency-1710-1785MHz downlink frequency-1805-1880
Uplink and downlink are frequencies Communication from earth station to satellite in uplink and communication from satellite to earth station is downlink Always uplink freq.>downlink freq.
Uplink frequency is a frequency that goes from the ground to the satellite. Downlink frequency goes from the satellite to the ground.
12-14ghz
To avoid interference
uplink
It's an uplink. You must do the same crossword that I do! It's in today's.
The uplink is the transmitter than sends the data up to the satellite. This can take the form of a dish or a highly directional antenna. You typically see these directional antennas mounted on telescoping poles mounted on the top of TV station news vans.
downlink becouse frequncy / power low compare to uplink
For communication satellites the range is much higher than that of communication relay. Communication Satellite can cover up to several thousands of kilometers. For communication relay, the uplink and the downlink frequency is the same. But for communication satellites the uplink and the downlink frequencies are different in order to avoid interference.
It is an electronic device on board a geostat satellite to receive uplink data and picture bits,amplifying it before converting it to a downlink freqency bit stream and sending it down to earth.
due to path loss : higher is the frequency higher is the patrh loss
You would need to know the LO frequency from the satellite. Ex- C-band is 2200Mhz If you UL is 6.0GHz you DL would be 3.8GHz