answersLogoWhite

0


Best Answer

EASY!------disconect Neg battery terminal, Pull fuse for airbag from panel-#3, remove lower panel below steering wheel, find Yellow wire/cable connector, pry out Green plastic lock pin then Unplug yellow conection.............Done

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you disable airbag in 1994 Chevy Corsica?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you disable the passenger airbag on a 1994 dodge ram 1500?

A 1994 Ram does not have a passenger side airbag.


What does a 1994 Chevy Corsica look like?

it looks like a corsica


How do you disable the airbag on a 1994 GMC Safari?

Why would you want to do this?


How do you change the heater core on a 1994 Chevy Corsica?

cost to replace heater core 1994 corsica


Does a 1989 corvette have a passenger side airbag and if so can you disable it?

== == No,the driver airbag arrived in 1990 as standard and the passenger airbag in 1994 as standard too.


How many miles per gallon does a 1994 Chevy Corsica get?

A 1994 Chevy Corsica gets 25 mpg city, and 31 mpg on the highway estimated. The mileage will vary depending on conditions.


Where is the fan relay located on a 1994 Chevy Corsica?

The 1994 Chevy Corsica fan relay switch is located beneath the passenger side dashboard. The fan relay switch should be labeled as such.


Where is the low-pressure switch on a 1994 Chevy Corsica?

under the carpet.


How do you find wiring color codes for a 1994 Chevy Corsica?

ALLDATA.COM T HEMPLE


How do you repair a 1994 Chevy Corsica?

Push it off the wharf would be a good start.


Where is the heater core in a 1994 Chevy Corsica?

Its located in the center of the vehicle below the dash.................


How do you replace ignition switch for a 1994 Chevy Corsica?

Remove the retaining ring at the top of your 1994 Chevy Corsica ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.