Want this question answered?
i need to disable jeep factory alarm 1997 cherokee
The factory alarm can not be disabled, only repaired if malfunctioning.
The factory alarm is reset by unlocking the doors with a key or remote.
You will have to uninstall the alarm and rewire the vehicle. It is likely the ignition wires are run through the alarm.
how to disconnect alarm in a 2000 pontiac grand am se
on my 1993 jeep GCL i removed fuse 6 and 7 from the fuse box to disable my alarm i hope this helps
== == We found it located in behind the right side of dash board, in behind the glove box. For our 1993 Jeep Grand Cherokee Laredo
There is a plug in "black box" under your dash that can be unplugged to totally disable the alarm system. The remote clicker should still work but the factory alarm will not. Nothing else will be affected. You'll have to get a flashlight and look under there but the box in question does have a sticker on it that clearly says "alarm/security" on it.
The only way i found to disarm the alarm was to use the back hatch lock. lock it and unlock it a few times with the key. if this doesnt work try the door locks
that is not going to be possible because gm has a anti-theft system on all grand am's 1999 and newer and if you try and steal it it will run for a few seconds then die and the security light will come on and disable the fuel pump
You can not. The "alarm" is an integral part of at least three computers on the Jeep. The pcm (engine), bcm (body functions), and the skim (chip key system).
The alarm system on your Jeep Grand Cherokee is controlled by a small, approximately 3 inch square box that plugs into wiring under your dash on probably the drives side towards the middle. It is black in color and is printed with the words "alarm module. If you unplug that the alarm system will be permanently disabled and starting issues may be resolved as well.