Check the manual. It should be listed after closed circuit video monitoring systems and just before the part about slim-jims and slide hammers.
i need to disable jeep factory alarm 1997 cherokee
The factory alarm can not be disabled, only repaired if malfunctioning.
You can not. The "alarm" is an integral part of at least three computers on the Jeep. The pcm (engine), bcm (body functions), and the skim (chip key system).
The alarm system on your Jeep Grand Cherokee is controlled by a small, approximately 3 inch square box that plugs into wiring under your dash on probably the drives side towards the middle. It is black in color and is printed with the words "alarm module. If you unplug that the alarm system will be permanently disabled and starting issues may be resolved as well.
You will have to uninstall the alarm and rewire the vehicle. It is likely the ignition wires are run through the alarm.
the aftermarket alarm kit
how to disconnect alarm in a 2000 pontiac grand am se
on my 1993 jeep GCL i removed fuse 6 and 7 from the fuse box to disable my alarm i hope this helps
I shut mine off by crossing the wire on the sensor; strip the protective palstic from the wires and twist them together. Probably a bad sensor that opens the loop to the alarm system.
Check Google.com
There is a plug in "black box" under your dash that can be unplugged to totally disable the alarm system. The remote clicker should still work but the factory alarm will not. Nothing else will be affected. You'll have to get a flashlight and look under there but the box in question does have a sticker on it that clearly says "alarm/security" on it.
it could be the factory alarm system