Unplug it and earth the incomming wire (not the plug) it to the body of the vehicle.
plug the seatbelt in.. the warning stops then ;-)
Pull the key out just a little and the chime will stop. It may be controlledfrom the radio
You can disable the seatbelt warning chime, in your Honda CRV, by removing the fuse. The fuse can be found in the fuse box in the engine compartment.
Yes, you can disable the warning chime on a 2001 Pontiac Grand Am by locating the chime module, which is typically found under the dashboard. You can either disconnect the module or remove the specific wire that triggers the chime when the door is opened with the key in the ignition. However, be cautious as this may affect other warning sounds in the vehicle. Always consult your owner's manual or a professional mechanic for guidance.
You can unplug it. Its under the dash board
there should be a plug in under your drivers seat drive safe
Drive it off a cliff or head on with a semi :) just jump out before impact!
if you have the owner book that came with the vehicle, you can find in the book how to disable the door chime
The chime module is under the dash on the right of the steering column. To disable the Key-in ignition warning chime simply cut the Black/Pink wire. Its a 7 pin harness going into a large black box. Easy test is to put your key in, open the door and hold the black box with the wire harness still attached next to your ear. Then simply cut the wire to quiet it.
The chime can not be disabled or removed.
instructions to disable chime can be found in the ownere handbook that came with the truck it is disabled thru the computer in truck
I was told that in the Expedition 2004 you can push the belt release button when the chime is going off and that stops it until the door is opened the engine is turned off. Good Luck