0
Check your fuse box far the lowest fuses and then pull one by one out until the alarm goes of. Or check under your seat, most of the cars seat belt sensor is underneath the seat and then you can just pull the plug out. The sensor can also be inside your dashboard behind the light of your seat belt light. Or if you can find the small speaker then you can pull the wire out.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you disable the alarm on a 1994 Chrysler new yorker?
The easiest way to disable your 1994 Chrysler New Yorker alarm is to remove the alarm fuse. The alarm fuse can be found in the fuse box.
How do you disable a factory alarm system in a 1990 new yorker?
if it is the same model as in M
How do you disable the alarm system on a 1998 New Beetle?
if you have a hatch back you can deactivate alarm system by placing key in hatch back and simply openning door
How do you temporary disable car alarm on a 2000 Dodge Intrepid you lost your remote and decided to do with out it Today your husband put in a new battery and enabled the alarm Now car wont start?
pull out the fuse for the alarm and that will disable the alarm then just start it up Try unlocking the drivers door with the key, there should be a switch on the back of the key cylinder to turn alarm off.
How do you disable the alarm system in a 1994 Chrysler new yorker?
It can not be permanently disabled. It is disarmed with the remote or by unlocking the doors with a key.
How do you disable the alarm that won't turn off for 1999 Honda passport or izusu rodeo?
The alarm will go off if the keyless entry has quit working. the keyless entry and alarm module is behind the glove box in the right corner. There is no way to bypass this module. The dealership will charge you out the ass for a new one. But back to the point, the key will disable the alarm. When the alarm goes off when you unlock the driver or passenger door, lock the driver door and unlock it again with the key. It should go off the first time you unlock it, but if it doesn't, lock it and unlock it again. This should disable the alarm. Atleast it does on my Rodeo.
You have 1999 Ford Windstar factory alarm had to install new battery when you went to start the van the security alarm light begins to flash very fast when trying to crank van will do nothing you have?
You can try to turn the key left and then turn back to right for disable the alarm
How can you bypass or disable a factory alarm on a 1997 G M C Yukon had to replace original ignition switch and key never had a alarm remote for Yukon?
The new chipless key, or unmatched key will need to be reprogrammed into the cars computer.
How can you disable a car alarm for a 1995 Chrysler LHS?
manualy unlock the passenger door with your door key,while the alarm is going off.it may take a few trys but it will work. the car wont start after alarm going off, do i need a new battery or can i just turn off the alarm and the car is a 1994 Chrysler lhs
What makes a 1989 jeep Cherokee run for a few seconds then kill?
Is it possible that the Jeep is a Laredo with an alarm. My jeep did the same thing after I installed a new starter. What I had to do was close the driver side door, lock it, and then unlock it to disable the alarm. Hope this helps.
How do you programme new fob for vauxhall omega?
By design, they can only be programmed by those possessing the correct equipment. If this were not so, anyone could buy a fob, program it to a vehicle, and then disable the alarm.
Who was the last Beatle to release a new solo album?
Paul McCartney
