The Enhanced Warning System (BeltAlert) can be enabled
or disabled by your authorized dealer or by
following these steps:
NOTE: The following steps must occur within the first
60 seconds of the ignition switch being turned to the ON
or START position. DaimlerChrysler does not recommend
deactivating the Enhanced Warning System
(BeltAlert).
1. Turn the ignition switch to the OFF position and
buckle the driver's seat belt.
2. Start the engine and wait for the Seat Belt Warning
Light to turn off.
3. Within 60 seconds of starting the vehicle, unbuckle
and then re-buckle the driver's seat belt at least three
times within 10 seconds, ending with the seat belt
buckled.
NOTE: Watch for the Seat BeltWarning Light to turn on
while unbuckling and off while re-buckling the seat belt.
It may be necessary to retract the seat belt.
Put your seat belt on
Wear it!
For about 10 bucks you can get a clip. go to shhding.com
find the fuse for the alarm if the fuse sevices alarm only remove the fuse other than that basically you are stuck with the alarm
go on youtube and fallow directions for older charger models its the same
Belt
The 3.8L has a chain. The 4.0L has a belt.
Chain
You can tighten the serpentine belt on your 2005 Chrysler 300 by tightening the tensioner pulley. Push the tensioner pulley to the right until the serpentine belt is tight.
Wear your seatbelt It is the law in most states.
Chain
Wear your seatbelt and the alarm will go off. If it will not go off when you hook the belt up, take it back to the dealer for repair. It is still under warranty.