answersLogoWhite

0


Best Answer
Copy
  1. Disconnect the negative battery cable.
  2. Drain the engine coolant into a clean container for reuse.
  3. Raise and safely support the vehicle.
  4. Remove the rear lateral transaxle strut mount, if necessary.
  5. Remove the drain tube and disconnect the heater hoses from the core tubes, lower the vehicle.
  6. Remove the sound insulators, console extensions and/or steering column filler, as required.
  7. Remove the floor console outlet ductwork and hoses.
  8. Remove the heater core cover.
  9. Remove the heater core mounting clamps and remove the heater core.

This information was taken from chiltons auto repair manual. So good luck and hope it works out.

User Avatar

Wiki User

โˆ™ 2015-07-15 19:55:22
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you disassemble the heater core in a 1992 Buick Skylark?
Write your answer...
Submit

Related Questions

How do you change heater core in 1992 buick skylark?

Im asking how to change the heater core. I don't have the answer.


How do you replace the heater coil in a 1992 Buick Skylark?

The heater CORE is a big job. Get a manual on your car to do the job correctly.


Where can you find a wiring diagram for a 1992 buick skylark?

A wiring diagram will make sure that everything is connected correctly. The wiring diagram for a 1992 Buick Skylark can be found in either of its manuals.


Where is the speed sensor located on a 1992 Buick Skylark 3.3L?

On the trans.


What is the normal temp on a 1992 Buick Skylark?

Around 200 degrees.


How do you replace a heater core 1992 Buick century?

replace heater core on 92 buick century


Why won't a 1992 Buick Skylark stay running?

It's the PCV pipe.


What is the firing order for a 1992 Buick skylark?

Check under related links.


Where are sparkplugs on Buick skylark 1992?

Just follow the spark plug wires....


Where do you find the horn relay switch on a 1992 Buick skylark?

if i knew i wouldnt be asking


What is the best type of oil for a 1992 buick skylark?

5w30 Your brand. Most are all the same


How do you change the clock on a 1992 Buick Skylark?

Press "SET" and then use the keys on the bottom right of the radio.


Where is the fuel filter located on a 1992 Buick Skylark?

It's behind the fuel tank near the bumper.


Where is the heater core on a 1992 Buick Century?

Under the glove compartment.


How do you fix the heater on a 1992 buick lesabre?

my heat won't work


Does a 1990 Chevrolet Lumina have the same engine as a 1992 Buick Skylark?

I looked them up and they both had 3.1 V6 engines. For some reason the Buick has more horsepower.


How do you change a heater core in a 1992 Chevy s10 blazer?

Disassemble the dash and open up the HVAC compartment.


Can you get to the heater motor on a 1992 buick regal through the dash?

it's on the outside on the passenger side.near the heater core hoses.


Where can you find a diagram or photography of the 1992 Buick Skylark timing belt tensioner system on the internet?

tyr edmonds.com try edmonds.com


Where is the oil filter located on a 1992 Buick Skylark V6?

On my 92 Buick Skylark my oil filter is right under the alternator in that area right next to the shocks housing, its is pretty clear to see you have a little bit of room to work with but you should be able to get it. Good Luck


1992 Buick Skylark water pump removal and installation?

Look for a Chilton's or Haynes manual on Amazon or Ebay. They're very cheap.


What is the average oil pressure reading in a 1992 Buick skylark?

My oil pressure is usually slightly below the 40 mark on the oil guage.


Where is the oxygen sensor in a 1992 Buick Skylark?

the oxygen sensor is located in/on the exhaust manifold.it looks like a spark plug with a wire coming out of the top


How do you change the blower motor in a 1992 Buick Skylark?

Get a Chilton's or Haynes repair book. Amazon or eBay should still have them and dirt cheap too.


What is the spark plug gap for a 1992 Buick Skylark with a 6 cylinder engine?

I think it's .06 but if you get Bosch Platinum plugs, you won't have to worry about it.