answersLogoWhite

0


Best Answer

you touch both of it's high voltage outputs together.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you discharge a flyback transformer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a flyback inverter?

fly back inverter is such kind of DC-AC inverters which use the flyback transformer for the low dc-high dc stage of the inveter shortly it's DC to AC inverter with flyback transformer inside .


What is meant by LOT in CRT monitors?

its a line output transformer, also known as a flyback transformer, it provides the high votage required to run the tube. http://en.wikipedia.org/wiki/Flyback_transformer


If a television high voltage regulator opens what is the likely to be the symptom?

In most sets, the HV regulator actually regulates the B+ voltage to the horizontal output transistor and the flyback transformer. A bad regulator indicates high current or loss of horizontal drive. Check the flyback transformer, the HO transistor and also look for proper waveform and voltage from the horizontal driver transistor/chip.


What is a flyback?

A type of high voltage transformer. Their most common use was in CRT based TVs & computer monitors to generate the anode high voltage and horizontal sweeps.


Will a 6v flyback coil provide a shock free spark?

No. Atleast i have yet of have seen a flyback transformer that could produce a 50khz+ 0.1 amp spark. the effect your looking for can be produced by a low output Hand held Oudin/tesla coil Aka "violet ray" or "violet wand"


What is the function of TV flyback?

The TV flyback transformer is obsolete in modern television sets and is not used.In the old cathode ray tube (CRT) television sets the flyback transformer had two functions:generate a large and powerful current pulse to drive the horizontal deflection coil in the yoke around the neck of the tube to create a quick horizontal retrace between sweep linesusing a large secondary autotransformer winding produce a very high voltage (i.e. 15KV to 100KV) rectified by a high voltage diode needed by the anode of the CRT to accelerate the electron beam


Is a tv main and power and the flyback transformer the same thing?

the main or power transformer is your iron and copper variety to get all the voltages to supply various circuitry fly back is ferrite in a resonant tank on the 15Khz to get the 10Kv for the second anode of the crt


Can a flyback transformer be powered by nothing but a car battery and wires?

A transformer is an AC device in that it requires a changing current to be input in order to see an output. Attaching a 12V battery to the primary side of the transformer will generate a voltage on the secondary for a short amount of time. Once the primary current has risen to a stable level, there will be no output voltage on the secondary. There will also be voltages on the secondary and the primary when the battery is disconnected from the transformer. A flyback transformer relies on an AC current at the primary to generate a high voltage at the secondary output. Circuitry to make changes to the primary current will be needed in addition to the battery. Warning: removing the battery from the primary winding of the transformer is liable to generate a very high voltage across the primary coil as well as the secondary. In some cases, they can be lethal. Do not experiment with transformers unless you are properly qualified and supervised.


Why partial discharge test in dry type transformer?

to check if any air voids are present in casting


What causes sparking?

It depends on the type of sparking/arcing. If you mean in a DC or series-wound motor, it is caused by the making and breaking of the commutator segments against the motor brushes.If you mean under a car, then it could mean that the muffler is dragging the ground.If you mean in a CRT television, then it is likely problems with the flyback transformer.


How does the Tesla Coil work?

it has a discharge sphere that does that. but the electricity has to be treated by a transformer, capacitor, spark gap, primary coil and a secondary coil. after that the sphere released the charge.


How types are SMPS?

SMPS are mainly 4: flyback pushpull halfbridge full bridge