Want this question answered?
If you have factory alarm, you have a right light blinking in the dashboard (on the top of the light there is word "alarm") when the alarm is on. If you have aftermarket alarm, then the blinking light is usually to left of the steering wheel next to mirrors regulator.
To turn off the factor alarm on a 2001 Toyota Celica, place the key in the door and unlock it. If this does not disconnect the alarm, place the key in the ignition and turn it over.
my 2001 diamante radio wont turn on after i put the code in
the factory alarm has a power circuit, find it and remove the appropriate relay, fuse, or connector... the library should have a pro shop manual available with all the info about the factory alarm... good luck:)
The factory alarm does not have individual fuses. The engine and body computers both control portions of the alarm.
Factory Alarm Disarm dk. green/purple - driver kick panel the factory alarm disarm wire is found under the driver kick panel and is dark green with a purple line... i found this on http://www.the12volt.com/installbay/forum_posts.asp?TID=45877
If you lock the doors from the inside by using the lock button, the alarm will not sound. If you lock the doors from the outside by using either the key or the remote control, the alarm is set to active.
The 2001 Dodge Neon factory alarm system does not have a reset switch. Instead, you need to insert the key into the driver's door and turn to unlock the door. Next, turn the key clockwise to initiate the alarm and turn counterclockwise to stop the alarm. Once you stop the alarm, it will reset itself.
For a 99 it is behind the right rear quarter trim panel.
Maybe there is a fuse that can be removed.
where is the thermostat own 2001 mitusbish iamante
My '98 intrepid will arm/disarm the factory alarm when you use the key in the driver's side door. Maybe that works on a 2001 also?